RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: Twin-star
Showing results 1 to 15 of 15
Search took 0.64 seconds.
Forum: RC Jets
04-22-2022, 06:07 AM
Replies: 2,625
Views: 737,568
Posted By Twin-star

Hi Guys, I was wondering what is the best way to...

Hi Guys, I was wondering what is the best way to set the elevator in line with the tailplane as a starting point for the maiden?
Thanks :)
Ian
05-03-2011, 03:46 AM
Replies: 1
Views: 432
Posted By Twin-star

4 Bladed Props

Hi Guys
I am building a P61 Black Widow using twin 1.5kW motors. I need to get 13"x13" four bladed props. Apparently APC make them but I cannot find anyone who sells them in the UK. Are there any...
04-24-2008, 03:31 PM
Replies: 1,020
Views: 167,377
Posted By Twin-star

RE: Eletronic engine syncronizer **SUPPORT **

Hi Guys
Looking for some advice again!! :D
Have fitted the twinsync to a Harmony twin. Running firmware version 1.4.4 with on board glow drivers and remote display. The rx is a JR 7 channel SPCM...
04-04-2008, 06:01 AM
Replies: 1,020
Views: 167,377
Posted By Twin-star

RE: Eletronic engine syncronizer **SUPPORT **

Thanks for the info I will check it out and see what happens.
Ian
04-03-2008, 07:27 AM
Replies: 1,020
Views: 167,377
Posted By Twin-star

RE: Eletronic engine syncronizer **SUPPORT **

Hi Guys
Have searched the forum but cannot find out the info I want (Or else I'm just going blind in my old age!! :D)
I have several Twinsyncs and love them. But this is the first time I have...
01-18-2008, 11:21 AM
Replies: 60
Views: 13,033
Posted By Twin-star

RE: Fuel tanks for Hobbico Twinstar

Hope thats not for a long while!!!!!!!! It really is a great plane and flies SOO well. :D
Ian
01-17-2008, 10:28 AM
Replies: 2,355
Views: 485,938
Posted By Twin-star

RE: KMP F-7F Tigercat

Thanks Vkerster for the input. I had noted earlier on in the posts that your beautiful TCat had the G26s installed until its very sad demise. (My thoughts were with you man, I lost my twin Harmony...
01-17-2008, 10:09 AM
Replies: 60
Views: 13,033
Posted By Twin-star

RE: Fuel tanks for Hobbico Twinstar

Hi Bassomatic
The pipes are just run as per the photos and inside the wing is virtually a straight run as the wing ribs have a hollow centre.
It is very straight forward really.
Ian
01-16-2008, 03:00 PM
Replies: 60
Views: 13,033
Posted By Twin-star

RE: Fuel tanks for Hobbico Twinstar

Sorry Guys forgot to say, the tanks are Kavan 4oz.
Ian
01-16-2008, 02:56 PM
Replies: 60
Views: 13,033
Posted By Twin-star

RE: Fuel tanks for Hobbico Twinstar

Hi Bassomatic and Sarah
Therotecially there should be a small change in the trim as the tanks empty but at the end of the day there is a thoretical change anyway in the standard setup as the...
01-16-2008, 10:02 AM
Replies: 60
Views: 13,033
Posted By Twin-star

RE: Fuel tanks for Hobbico Twinstar

Hi Guys
Pictures as requested.
I removed part of the top balsa sheet of the wing very carefully. Then I ran the pipes through the wing, replaced the sheet and put on new solarfilm. The pressure...
01-15-2008, 01:48 PM
Replies: 60
Views: 13,033
Posted By Twin-star

RE: Fuel tanks for Hobbico Twinstar

Hi Guys
I added two extra 4 oz tanks attached side by side to the centre of the top surface of the wing of my twinstar plumbed them up using the tanks in the nacelles as if they were header tanks...
01-15-2008, 01:19 PM
Replies: 2,355
Views: 485,938
Posted By Twin-star

RE: KMP F-7F Tigercat

Guys
I am building a YT Tigercat which is the British version of the KMP. I am keen to put in petrol engines but am torn between the Zenoah G20Ei and the Evolution 26GT. As you guys seem to have...
08-16-2007, 01:44 PM
Replies: 1,020
Views: 167,377
Posted By Twin-star

RE: Eletronic engine syncronizer **SUPPORT **

Thanks Blade and yl5295 for the info!! ;)
I assume that it would be fine to graft the red wire onto any +ve supply line?
Ian
08-16-2007, 04:29 AM
Replies: 1,020
Views: 167,377
Posted By Twin-star

RE: Eletronic engine syncronizer **SUPPORT **

Guys
I would really appreciate any input re the remote display units.
I have a twinsync with a 2 pin connector on the board, this is according to the manual the display connector and has one pin...
Showing results 1 to 15 of 15


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.