RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: soar-iowa
Showing results 1 to 9 of 9
Search took 0.50 seconds.
Forum: The Clubhouse
02-03-2010, 10:55 PM
Replies: 5
Views: 730
Posted By soar-iowa

rcu changes the word ebay to rcu

I tried responding to a question in for sale ad. Rcu changes the word bay as in (ebay) into (rcu). Wow just like the chinese. curious how this posting will change when posted.
is "ebay a forbidden...
02-23-2006, 09:40 PM
Replies: 4
Views: 787
Posted By soar-iowa

RE: Storing Hi-start

Iv'e heard to take it off the spool so there is no tension. and store it in a waxed bag. Like a donut bag.[&:]
08-24-2003, 02:09 AM
Replies: 11
Views: 2,607
Posted By soar-iowa

winch

redline I use a 6v motor on 12 volts. Gives lots of power. I think all our club winches are 6 volt also.
08-24-2003, 02:00 AM
Replies: 5
Views: 1,402
Posted By soar-iowa

huh?

I don't want to be negative.

But....


I can't see the ace foam wings worth a darn on a slope plane.

Usually used on .049 stuff
08-05-2003, 11:51 AM
Replies: 9
Views: 1,060
Posted By soar-iowa

help - rubber high starts vs. elastic bungee hi starts

I think the cloth covered bungee type won't strech as far and is heavier. I looked at buying some bungee but decided I would not like it for thermal airplanes. Probably good for short launches for...
05-29-2003, 02:20 AM
Replies: 3
Views: 747
Posted By soar-iowa

Winch project completion

Looks good and looks like alot of work. Hope you had fun.. We use two roller bearings in the front housing that are an exact fit for the bushing . And don't mess with the rear end plate. Works great...
09-24-2002, 12:31 AM
Replies: 11
Views: 1,180
Posted By soar-iowa

Spirit

I would add carbon to top and bottom of spars. Like .007. It really helped mine on winch launchs'. I would add spoilers. If you don't use them you could always tape them down. It's darn near...
Replies: 2
Views: 846
Posted By soar-iowa

Try

Better hardware stores have it. Be aware that I have seen stores sell only one-half of the material. One should be with pins close together the other should have gaps. This stuff is very strong and...
04-13-2002, 01:27 AM
Replies: 18
Views: 2,708
Posted By soar-iowa

How about

Wing warp? Did you try A heat gun to the wing?

How about the swing plus

http://www.rcmodelairplanes.com/SWING%20PLUS.HTM

I don't have one but looks good for the money
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.