RCU Forums - Search Results

Search: Posts Made By: doeseburg

Showing results 1 to 6 of 6
Search took 0.62 seconds.

Forum: RC Gliders, Sailplanes and Slope Soaring

08-12-2004, 08:36 PM

Replies: 200

Cloud Bound 4

Views: 45,547

Posted By doeseburg

RE: Cloud Bound 4

I'm removing the covering to take out some weight in the tail section - by various methods - it's now over-built because I didn't see Ray's tips until I was done with the fuselage.

Oh,...

Forum: RC Gliders, Sailplanes and Slope Soaring

08-12-2004, 12:16 PM

Replies: 200

Cloud Bound 4

Views: 45,547

Posted By doeseburg

RE: Cloud Bound 4

I got my cloudbound4 back in December of 2003 and am still putting it together. I was pretty much done with the major building in late May, but have been having issues since.

Here's tips I'll...

Forum: Kit Building

04-02-2004, 12:57 PM

Replies: 1

Aligning V-tail

Views: 507

Posted By doeseburg

Aligning V-tail

I'm almost finished with my winter project - a Skybench Cloudbound4 sailplane. I'm at the point of attaching the V-tail to the fuselage. The problem I'm having is how do I align the V-tail relative...

Forum: Kit Building

12-29-2003, 01:14 PM

Replies: 4

Wing sheeting problem

Views: 902

Posted By doeseburg

Wing sheeting problem

Hi All,

I'm building a Cloud Bound 4 glider from Skybench. I put the sheeting on the leading edge, but notice after it was sealed up that a few of the ribs were not completely sealed to the...

Forum: Kit Building

09-24-2003, 12:13 PM

Replies: 6

Tires on StaggerBee

Views: 1,047

Posted By doeseburg

Tires on StaggerBee

I'm building a Stagger Bee, and the kit came with tires that I'm having trouble figuring out how to inflate properly. The tires look like minature inner-tubes, with a small tube (made of the same...

Forum: "1/2 A" & "1/8 A" airplanes

09-13-2003, 09:48 PM

Replies: 11

Hitec 3 channel Single Stick Radio

Views: 1,417

Posted By doeseburg

RE: Hitec 3 channel Single Stick Radio

Aha!!!, that's why my Vermont Belle kept going into a nosedive at the end of the field. I was doing fine with it out to that distance and then there was basically no control. Thanks for the tip,...

Showing results 1 to 6 of 6