RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: kinotonman
Showing results 1 to 25 of 57
Search took 0.62 seconds.
Forum: RC Jets
10-02-2007, 10:47 AM
Replies: 2,137
Views: 267,050
Posted By kinotonman

RE: Futaba FASST 6

Can someone just clarify that the current FF9 tx 7 ch. module will only work with the 7 ch. receiver and not be compatible with the new 8ch rx when they come out later in the year?

Thanks in...
Forum: Giant Scale Aircraft - 3D & Aerobatic
09-14-2007, 03:39 PM
Replies: 4
Views: 891
Posted By kinotonman

50cc Yak 55?

I know that every model manufacturer now has produced a Yak 54 of some description. I am however very taken by the Composite ARF Yak 55. Problem is, at 2.6m it makes it too big to make it a...
Forum: Questions and Answers
08-15-2007, 09:20 AM
Replies: 1
Views: 667
Posted By kinotonman

6 volt regulator causing range problem??

Upon range checking my latest project I noticed I was getting to around 30 paces and the Futaba 149PCM receiver would go into fail safe. Further investigation revealed that if I unplugged the...
Forum: Giant Scale Aircraft - 3D & Aerobatic
08-15-2007, 09:01 AM
Replies: 0
Views: 450
Posted By kinotonman

z

.
Forum: Batteries & Chargers
08-13-2007, 02:44 AM
Replies: 5
Views: 681
Posted By kinotonman

RE: Going LiPo, need help...

Something along the lines of a 2 cell (7.4volt) 2500mah lipo connected to a 6volt regulator would be a sensible 'ball park' starting point without overcomplicating matters.
Forum: WildHare R/C Support
08-06-2007, 07:34 AM
Replies: 1,855
Views: 188,054
Posted By kinotonman

RE: New Wild Hare Sukhoi ready to fly

Mine is nearly finished with a 3W 80XI single and cannister, balances nicely and should be plenty of power with the 27x10 prop
Forum: WildHare R/C Support
08-05-2007, 01:37 PM
Replies: 1,855
Views: 188,054
Posted By kinotonman

RE: New Wild Hare Sukhoi ready to fly

Anyone running single 5955's per aileron? I know this has been discussed before but wandered if anyone has been having success with this setup??
Forum: Gas Engines
06-19-2007, 08:04 AM
Replies: 38
Views: 4,169
Posted By kinotonman

RE: 50cc engine light and low cost ?

Just got my DL 50 for my 28% Ohio models Ultimate. Installed a Biela 22x8 carbon prop, used mounts and silencer supplied, primed and choked it...started first flick!! All I can say is the big boys...
Forum: Gas Engines
06-13-2007, 05:32 PM
Replies: 5
Views: 1,085
Posted By kinotonman

RE: 3W 80XI Carb query?????

Very nearly ready for an engine run! Since crushing my little finger with a mallet Saturday I've been feeling a bit sensitive about spinning large props!!!

Daz
Forum: Gas Engines
06-12-2007, 06:08 PM
Replies: 5
Views: 1,085
Posted By kinotonman

RE: 3W 80XI Carb query?????

Many thanks Dan, Is it best practice to attach some tubing to the vent nipple to aid breathing? (Their is no mention of this in the instructions.....)

Now I know where to start!

Thanks
Forum: Gas Engines
06-12-2007, 03:03 PM
Replies: 5
Views: 1,085
Posted By kinotonman

3W 80XI Carb query?????

Guys,

Am installing a 3W 80XI single and am trying to figure out why the carb body has 2 fuel inlet nipples? Its not a Walbro carby (what I'm used to), Its a tilotson. One nipple is located at...
Forum: WildHare R/C Support
05-07-2007, 06:07 PM
Replies: 1,855
Views: 188,054
Posted By kinotonman

RE: New Wild Hare Sukhoi ready to fly

Talbs,

Is that 8711's on all surfaces just one servo per aileron and one for the rudder? How does it perform with this set up? (if it is this set up!)
Forum: WildHare R/C Support
04-28-2007, 04:16 PM
Replies: 1,855
Views: 188,054
Posted By kinotonman

RE: New Wild Hare Sukhoi ready to fly

Chaps,

Has there been any feedback from anyone flying this bird on a 80cc motor? (3W XI or ZDZ80 etc)
Forum: WildHare R/C Support
04-19-2007, 05:55 PM
Replies: 1,855
Views: 188,054
Posted By kinotonman

RE: New Wild Hare Sukhoi ready to fly

Guys,

Can anyone please recommend suitable horns/pushrods etc for this plane? Do Dubro offer suitable hardware? I'm ok with 50cc gassers but 100cc makes me want to get the hardware right!

...
Forum: RC Flight Simulator Software
03-07-2007, 12:53 PM
Replies: 64
Views: 9,397
Posted By kinotonman

RE: Which simulator do you prefer among the best six?

But there again, AFPD is a bit floaty too!

Sorry Jim!

;)
Forum: RC Flight Simulator Software
03-07-2007, 12:10 PM
Replies: 64
Views: 9,397
Posted By kinotonman

RE: Which simulator do you prefer among the best six?

AFPD for sure. Phoenix is ok for helis but the fixed wing AI is very f l o a t y... like flying a foamy in zero wind conditions....
Forum: 3D Flying!
01-10-2007, 02:36 PM
Replies: 8
Views: 1,630
Posted By kinotonman

RE: New CmPro Extra 330L 3D

Thought I'd chip in here. I had one... no It didn't crash but was stolen from my garage.. The components were superb, used all stock hardware for a change and flew beautiful pattern lines. Motor used...
Forum: ARF or RTF
11-21-2006, 06:22 PM
Replies: 90
Views: 12,052
Posted By kinotonman

RE: GSP Yak54 is here!! I am liking this one!

Looks like you jumped on it?!
Forum: Giant Scale Aircraft - 3D & Aerobatic
11-03-2006, 07:03 PM
Replies: 7
Views: 2,362
Posted By kinotonman

RE: 3W 23% Pitts Challenger

I have one. Build quality is superb but came with no instructions. After several e-mails to Germany they eventually sent me a pdf file with pictures of some sort of build process.

Havent flown...
Forum: ARF or RTF
09-19-2006, 04:54 PM
Replies: 364
Views: 81,058
Posted By kinotonman

RE: CMP Kits – Problems and Solutions

Had experience with Yak 140 (No suggested control throws-scary maiden), Edge 540 (Super flying characteristics, all glue joints needed beefing up tho), Extra 300 140 size ( Superb airframe-no...
Forum: Giant Scale Aircraft - 3D & Aerobatic
09-06-2006, 06:13 PM
Replies: 274
Views: 29,041
Posted By kinotonman

RE: Updates on the Pitts Model 12

Want one!!
Forum: ARF or RTF
06-25-2006, 06:25 AM
Replies: 174
Views: 58,336
Posted By kinotonman

RE: CMP Extra 330L (2m) - new ARF

I have just received my Extra, very pleased with construction and quality of finish. I too will get the latest MVVS 45cc Petrol motor, seems like a perfect combo.. Hope to post some piccs when I...
Forum: Crash & Rebuild
06-16-2006, 06:37 PM
Replies: 16
Views: 3,023
Posted By kinotonman

RE: Cap 232 hard landing/video

Ah yes, the famous 'snap Cap'!! ....
Forum: RC Warbirds and Warplanes
04-28-2006, 05:30 PM
Replies: 554
Views: 95,525
Posted By kinotonman

RE: CMP/GSP P-40 , Build

I'll second that. The CMP vers. is amazing value for money, with just a little work you can have a P40 to be really proud of.
Forum: RC Warbirds and Warplanes
04-21-2006, 09:03 AM
Replies: 554
Views: 95,525
Posted By kinotonman

RE: CMP/GSP P-40 , Build

Thanks for the heads up re. c of g guys, presume this is done with the plane upside down? ( then the rec. c of g range at the gear pod doesn't become an issue either..??)

Am running a YS 140L...
Showing results 1 to 25 of 57
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.