RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: HELLRAZOR
Showing results 1 to 14 of 14
Search took 0.58 seconds.
Forum: Car Nitro & Gas Engines
12-21-2004, 08:37 AM
Replies: 5
Views: 712
Posted By HELLRAZOR

RE: To cold for break in?

Thanks guys! I just ran a couple of tanks through it and this thing is going to be ballistic. I'm going to have to wait for the pavement to warm up before I can open it up. Not even half throttle and...
Forum: Car Nitro & Gas Engines
12-20-2004, 01:19 PM
Replies: 5
Views: 712
Posted By HELLRAZOR

To cold for break in?

How cold is to cold for breaking in a new engine? I just got a new Rody Mod. RB .12 and I'm dieing to see how it runs in my NTC3. But it's 20 degrees out side and I don't want to kill a new engine.
Forum: RC Car General Discussions
01-20-2004, 08:36 PM
Replies: 1
Views: 1,421
Posted By HELLRAZOR

Torsen Diff ?

Can I replace the rear diff. with a torsen diff. and still use my stock diffs on the front and center with out creating a problem? If so, what weight diff lube should I use?
Forum: RC 1/8th Scale Buggies
01-07-2004, 08:25 AM
Replies: 3
Views: 493
Posted By HELLRAZOR

RE: what is first to break on Inferno RTR

Well, in my case it was the spur gear. Then the clutch bell after putting the steel spur gear on it. Next was the steering servo. So on and so on. The thing is every time you make one link stronger,...
Forum: RC 1/8th Scale Buggies
01-07-2004, 08:12 AM
Replies: 21
Views: 1,046
Posted By HELLRAZOR

RE: nitroaddict and others, engine advice.

The GS 21 isn't that bad of an engine if you do a little porting on it and throw the stock pipe away and replace it with a .063 pipe. But I did replace mine with a WS7 2 and It spanks the hyper 21's...
Forum: RC Car General Discussions
01-05-2004, 08:30 PM
Replies: 2
Views: 574
Posted By HELLRAZOR

RE: Drive Bevel Gear for MP 7.5

I've got the Inferno Sports RTR. I'm In the Process of upgrading it. I've found the drive bevel gear at Tower for 16.99. I'm thinking about getting the torsen diffs, but man are they expensive!
Forum: RC Car General Discussions
01-02-2004, 08:25 PM
Replies: 2
Views: 574
Posted By HELLRAZOR

Drive Bevel Gear for MP 7.5

Does anyone know if they make a hardened Drive bevel gear for MP 7.5 . I just installed a RB ws2 in my inferno and the stock differentials aren't strong enough.
Forum: RC Car General Discussions
11-28-2003, 05:58 PM
Replies: 18
Views: 2,259
Posted By HELLRAZOR

RE: KYOSHO INFERNO HOP UPS

I have a inferno sports and am also in the process of upgrading. So far I've put racers edge hop-ups. I've also just replaced the stock engine with a rb concepts .21 ws7
Forum: RC Car General Discussions
11-02-2003, 12:18 PM
Replies: 4
Views: 538
Posted By HELLRAZOR

RE: Glow Plug Problems?

Thanks guys. It was running to rich on top and bottom. I don't know how I got it that far out of adjustment but it was way off on top. Now I'm off to the track and test my suspension upgrades!
Forum: RC Car General Discussions
11-01-2003, 02:17 PM
Replies: 4
Views: 538
Posted By HELLRAZOR

Glow Plug Problems?

My GX .21 stalls when I remove the glow starter. I've tried three different glow plugs with no effect. It runs great if I attach a four AA's to the glow plug. What could be the cause.
Forum: JR Radio & Spektrum Radios
10-26-2003, 02:28 AM
Replies: 2
Views: 508
Posted By HELLRAZOR

OFNA Micro Fail Safe with JR RS300 receiver

Can I use a OFNA micro fail safe with my JR RS300 receiver.
Forum: JR Radio & Spektrum Radios
10-24-2003, 07:58 AM
Replies: 3
Views: 549
Posted By HELLRAZOR

RE: Best servo for 1/8 Off Road buggy

Thanks for the info.
I think my JR XS3 Rocks!
Forum: JR Radio & Spektrum Radios
10-23-2003, 08:05 AM
Replies: 3
Views: 549
Posted By HELLRAZOR

Best servo for 1/8 Off Road buggy

Which servos would be best for my inferno mp 7.5? I Have a JR XS3 radio with RS300 receiver. A Z590M for my throttle/Brake and A Hitec HS-645MG for steering.
Forum: RC Painting, Detailing & Bodies
10-18-2003, 09:53 PM
Replies: 0
Views: 444
Posted By HELLRAZOR

Paint Mask

[8D]What is the best paint mask and where can I get it?[sm=confused.gif]
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.