RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: jrmy23
Showing results 1 to 17 of 17
Search took 0.63 seconds.
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
08-04-2005, 08:39 AM
Replies: 4
Views: 451
Posted By jrmy23

RE: no tail wag

thanks for your help
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
08-03-2005, 05:23 PM
Replies: 4
Views: 451
Posted By jrmy23

RE: no tail wag

I have a Raptor 50 with the futaba 401 gyro and s9254 servo. I have never seen tail wag because the higher I put the gain the better the tail holds but I keep it around 80 because I read were to...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
08-03-2005, 12:57 PM
Replies: 4
Views: 451
Posted By jrmy23

no tail wag

I have my tail servo arm set at the fourth hole out which is about 18mm from the center and with the gain at 100% I don't have any tail wag. Should I be going further out than 18mm or is there...
Forum: Beginners
02-27-2005, 05:50 PM
Replies: 8
Views: 642
Posted By jrmy23

RE: flying with cowling removed

thats some good news thanks.
Forum: Beginners
02-27-2005, 04:51 PM
Replies: 8
Views: 642
Posted By jrmy23

flying with cowling removed

I was wondering if I would be able to fly my thunder tiger trainer with the cowling removed. It becomes a pain to take it on and off when you need to work on something and also if it was removed I...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
02-05-2005, 05:21 PM
Replies: 5
Views: 747
Posted By jrmy23

RE: clutch problem

I have a size 50 raptor and yes I think you were right about the clutch hitting the bell. I tighten the nut on the crank shaft and the engine mount holes seem to line up better than they did.
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
02-05-2005, 12:37 PM
Replies: 5
Views: 747
Posted By jrmy23

clutch problem

I went to fly my raptor for the second time and when I went to start it wouldn't turn over becouse the clutch was engaged. I took the engine out and reinstalled it thought I had it fix but it did...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
12-21-2004, 10:10 AM
Replies: 4
Views: 589
Posted By jrmy23

RE: Having a problem with pitch of main blades

I understand what you are saying now
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
12-20-2004, 09:30 PM
Replies: 4
Views: 589
Posted By jrmy23

Having a problem with pitch of main blades

I just built my raptor 50 I have everything but the main blades on. I was reading the manual about the pitch and I notice just by looking at the gauge molded in the frame mine has very little + or...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-16-2004, 09:20 PM
Replies: 2
Views: 491
Posted By jrmy23

RE: radio glitching

thanks for your help I thought it might have been something more complicated.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-16-2004, 02:43 PM
Replies: 2
Views: 491
Posted By jrmy23

radio glitching

I have a problem with my radio glitching. It usually begins at the end of my second flight and is always on the same side of the field. By the time my battery voltage is around 5.2 volts it...
Forum: Glow Engines
09-02-2004, 12:55 PM
Replies: 4
Views: 635
Posted By jrmy23

RE: Air-bleed screw adjustment

I think I understand what you are saying. The reason I was asking is because I experienced a loss of power during take off and made a hard landing. I just bent the nose gear a little bit, got that...
Forum: Glow Engines
09-02-2004, 10:09 AM
Replies: 4
Views: 635
Posted By jrmy23

Air-bleed screw adjustment

When you rotate the nose up and down to make sure the engine will run smoothly do you do this at idle or at full throttle.
Forum: Batteries & Chargers
04-20-2004, 09:21 AM
Replies: 4
Views: 496
Posted By jrmy23

RE: Have a Problem

If I were to buy an aileron extension with the correct plugins would the yellow wire cause me problems when I don't have any current going to it.
Forum: Batteries & Chargers
04-19-2004, 12:07 PM
Replies: 4
Views: 496
Posted By jrmy23

Have a Problem

i had to move my battery pack aft on my aircraft so I could get the CG in balance. I ordered a Hitec male bec extension to splice onto my reciever battery. The plugin on my reciever battery is...
Forum: ARF or RTF
02-20-2004, 09:26 AM
Replies: 2
Views: 525
Posted By jrmy23

RE: building first airplane

thanks for the advice
Forum: ARF or RTF
02-19-2004, 10:00 AM
Replies: 2
Views: 525
Posted By jrmy23

building first airplane

I have a thunder tiger size 60 trainer with radio and engine already installed. My problem is the installion of the horizontal stabilizer. The manual states to install the vertical stab first but...
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.