RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: pakiji
Showing results 1 to 24 of 24
Search took 0.62 seconds.
Forum: Electric RC Helis
08-31-2004, 06:46 PM
Replies: 1
Views: 362
Posted By pakiji

RE: Aerohawk reciever/antennae problem? HELP

One more, much less important problem. After 60 seconds of continuous hover, my motor slows way down and I lose about a foot of altitude before recovering. Is this normal? Or is my motor abnormally...
Forum: Electric RC Helis
08-31-2004, 06:37 PM
Replies: 1
Views: 362
Posted By pakiji

Aerohawk reciever/antennae problem? HELP

So I can finally hover and do forward fight and now the DAMNED THING DOESN'T DO WHAT I TELL IT TO DO. Random throttle changes (either more or less: the last one cut out my motor about four feet above...
Forum: Electric RC Helis
07-12-2004, 03:12 PM
Replies: 3
Views: 639
Posted By pakiji

RE: Ikarus Free Wheel Kit?

Yes. The piccolo and the eco all come with one way bearings. The upgrade on the helihobby site is also a one way bearing.
Forum: Electric RC Helis
06-30-2004, 08:32 PM
Replies: 7
Views: 858
Posted By pakiji

RE: Direct Drive Tail Motor for Aerohawk

Thanks. Is there a link that shows the swashball mod step by step? Not sure how to go about it.
Forum: Electric RC Helis
06-28-2004, 01:54 PM
Replies: 7
Views: 858
Posted By pakiji

RE: Direct Drive Tail Motor for Aerohawk

OK, it turns out my hobby shop sold me the wrong item: instead of a GWS direct drive tail rotor, I have a slow-flyer geared propellor. Bloody hell. Well that answers one question, but anything on...
Forum: Electric RC Helis
06-28-2004, 01:51 PM
Replies: 4
Views: 503
Posted By pakiji

RE: Tail rotor malfunction

Sorry, just read the last few lines of your post. If you're flying inside, remember to turn off anything that could cause interference: I had that same problem, turns out it was just interference...
Forum: Electric RC Helis
06-28-2004, 01:47 PM
Replies: 4
Views: 503
Posted By pakiji

RE: Tail rotor malfunction

Sounds like a trim problem: adjust the trim setting for rudder control on the transmitter (just push it right). IF that doesn't work, I'm guessing you could adjust the gyro gain (not sure how to do...
Forum: Electric RC Helis
06-27-2004, 06:31 PM
Replies: 7
Views: 858
Posted By pakiji

RE: Direct Drive Tail Motor for Aerohawk

As soon as I gain access to a digital camera.
Forum: Electric RC Helis
06-27-2004, 01:41 PM
Replies: 7
Views: 858
Posted By pakiji

Direct Drive Tail Motor for Aerohawk

I'm converting to a direct drive tail motor (called the High Authority Larger Piccolo Motor) but I'm having trouble figuring out how to attach the new blade (its the orange one, the package doesn't...
Forum: Electric RC Helis
05-11-2004, 09:19 PM
Replies: 9
Views: 689
Posted By pakiji

What is the capacitor for? also how to take off metal gear of tail motor

I've recently had trouble with my tail motor on my Cupid micro heli (Aerohawk knockoff) and have no idea what purpose the capacitor serves on the tail motor (the main motor also has three of them)....
Forum: Electric RC Helis
05-06-2004, 01:44 AM
Replies: 21
Views: 1,313
Posted By pakiji

RE: Flybar control rod/ rotorhead problem

Thanks, although I haven't ordered the motors from the urls posted. I am simply too lazy and want to fly (also there was a slight problem of not having any soldering iron, or indeed any kind of...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
05-06-2004, 01:27 AM
Replies: 2
Views: 701
Posted By pakiji

JR XP6102 PCM or Futaba 9 Channel PCM 1024ZA

Hi,

I've recently come across the opportunity to buy a Futaba 9 Channel 9ZAS/WC2 for a (relatively) low price of about $500 CAN. I'm a newbie to the hobby, I have only one micro-helicopter and...
Forum: Electric RC Helis
04-23-2004, 09:10 PM
Replies: 21
Views: 1,313
Posted By pakiji

RE: Flybar control rod/ rotorhead problem

Also I'm a little leery of opening up the motor, anyone know a site that goes through the process of fixing this?
Forum: Electric RC Helis
04-23-2004, 09:09 PM
Replies: 21
Views: 1,313
Posted By pakiji

Tail motor problem. Also it's epileptic

Been busy writing final exams, but back to the important things in life:

The antenae comes out from the reciever board (unsure if that's the mixing board as well) winds itself around the right...
Forum: Electric RC Helis
04-16-2004, 02:02 AM
Replies: 21
Views: 1,313
Posted By pakiji

RE: Flybar control rod/ rotorhead problem

OK: new problem. I charge battery, put it in the battery case, clip the battery to the heli, turn the transmitter on, check to see if the throttle is set to zero on the transmitter, plug the battery...
Forum: Electric RC Helis
04-15-2004, 01:51 AM
Replies: 21
Views: 1,313
Posted By pakiji

RE: Flybar control rod/ rotorhead problem

Hey,

So got it fixed by the good ppl of my local hobby shop (Jet Hobbies is the ****, (da) BOMB, and the MAN): they replaced the rotorhead with an Aerohawk one, and flight trimmed it for me as...
Forum: Electric RC Helis
04-14-2004, 01:33 AM
Replies: 21
Views: 1,313
Posted By pakiji

RE: Flybar control rod/ rotorhead problem

Annnnd...I broke it. Like twenty minutes after the last post. I flew into a coffee table, the rotor head broke off at the point indicated below. Think I'll have that replaced instead of just gluing...
Forum: Electric RC Helis
04-13-2004, 11:34 PM
Replies: 21
Views: 1,313
Posted By pakiji

RE: Flybar control rod/ rotorhead problem

THanks, will take the advice to heart, and start saving up for glow and gas. (Though indoor flying seems incredibly cool.) Have replaced the control rod and I've actually managed to take off today...
Forum: Electric RC Helis
04-13-2004, 10:35 PM
Replies: 21
Views: 1,313
Posted By pakiji

RE: Flybar control rod/ rotorhead problem

ACtually, have found what I was looking for, a good pic of what needs to be done: http://www.wright-flyer.net/desertaviation/picollo/hub.jpg. and
...
Forum: Electric RC Helis
04-13-2004, 10:29 PM
Replies: 21
Views: 1,313
Posted By pakiji

RE: Flybar control rod/ rotorhead problem

Thanks AllisonMO2. ANy idea where I would find a pattern/instructions on making the head stiffener itself? I have access to aluminum of pretty thin guage.
Forum: Electric RC Helis
04-13-2004, 02:20 AM
Replies: 21
Views: 1,313
Posted By pakiji

RE: Flybar control rod/ rotorhead problem

Quaker:

LOL Yes, well, I happen to be rather skilled :). I think that it may have been cracked during shipping, so when I ran it the first couple times and tried out the cylcic and roll...
Forum: Electric RC Helis
04-10-2004, 07:41 PM
Replies: 21
Views: 1,313
Posted By pakiji

RE: Flybar control rod/ rotorhead problem

Well, fixed my swashplate problem (just replaced it) turned out to be easier than I thought to take off the rotor head. Still not sure about the strength of the control rods for the flybar. Don't...
Forum: Electric RC Helis
04-10-2004, 12:48 PM
Replies: 21
Views: 1,313
Posted By pakiji

RE: Flybar control rod/ rotorhead problem

ANybody....?
Forum: Electric RC Helis
04-10-2004, 04:31 AM
Replies: 21
Views: 1,313
Posted By pakiji

Flybar control rod/ rotorhead problem

Hi,

First time posting, new to helis, just got a slightly used (never flown) Cupid electric micro-heli (aerohawk/piccolo/etc knockoff, nothing fancy). The large bearing doesn't seem to sit very...
Showing results 1 to 24 of 24


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.