RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 15
1
2
3
11
Last »
Search: Posts Made By: fellers
Showing results 1 to 25 of 354
Search took 0.75 seconds.
Forum: RC Helicopter General Discussions
04-25-2010, 08:29 AM
Replies: 3
Views: 1,093
Posted By fellers

RE: Lipo, Regulator, and charger setup for guy getting back in hobby

Hey thanks man. That is exactly what I researched and purchased to the T.
Thanks for your respons
Forum: RC Helicopter General Discussions
04-09-2010, 07:39 PM
Replies: 3
Views: 1,093
Posted By fellers

Lipo, Regulator, and charger setup for guy getting back in hobby

Hey guys I have been around for a while then got out of the hobby due to babies for a while. Well I bought a new t rex 600n and do not want to power it with a single nimh pack like I used to.
Can...
Forum: Traxxas Monster Truck forum
04-06-2008, 11:29 PM
Replies: 26
Views: 2,286
Posted By fellers

RE: Keep blowing throttle servo!!!!!!!!!1

for Molsens revo his radio is JR and has EPAs. I set the radio up in it with no binding on throttle nor braking end. The next servo we are going to check it with my current / amp draw meter to see...
Forum: Traxxas Monster Truck forum
04-06-2008, 10:27 PM
Replies: 20
Views: 1,293
Posted By fellers

RE: What the hell is that noise?????

No reverse gears in mine. I have FOC mod. I am thinking the clutch is hung up against the clutch bell. ?? going to have to check it tomorrow.
Forum: RC Giant Scale Cars
04-06-2008, 10:00 PM
Replies: 18
Views: 1,641
Posted By fellers

RE: Big, Bad, Very Fast Bashing truck, which one...

Guys I do definately want quality. I don't know who said it above, "people aren't willing to pay for quality" because in my initial post i said price does not matter. If I have to get a rolling...
Forum: RC Giant Scale Cars
04-06-2008, 10:15 AM
Replies: 18
Views: 1,641
Posted By fellers

Big, Bad, Very Fast Bashing truck, which one...

Hey guys I am looking for a big very bad ***** gas truck to beat on in the big rock quarries around my house. I have a revo and it is cool and all done up for bashing but I want a bigger faster truck....
Forum: RC Car General Discussions
04-05-2008, 11:12 PM
Replies: 3
Views: 506
Posted By fellers

RE: Where is the gasser forum/ Also gasser question.

Thank you, I will head over to the giant scale forum.
Forum: RC Car General Discussions
04-05-2008, 11:06 PM
Replies: 3
Views: 506
Posted By fellers

Where is the gasser forum/ Also gasser question.

I am looking around and doing some research on what gasser to buy. I clicked on the 29.5cc head kit ad and watched some videos that had some pretty powerful BIG trucks. They were actually moving...
Forum: Traxxas Monster Truck forum
04-05-2008, 10:55 PM
Replies: 20
Views: 1,293
Posted By fellers

RE: What the hell is that noise?????

What if it only did it in reverse?
Seriously. Mine is doing that after running today. Forward is smooth.
I am thinking clutch or tranny.
Forum: Traxxas Monster Truck forum
04-02-2008, 12:03 PM
Replies: 34
Views: 6,932
Posted By fellers

RE: o.s. .21 tm?

Which engine are you going with ?
Even though the OS does not have a ton of low end you could always out a tuned pipe on to gain low end right?
I want more power and speed out of my revo for...
Forum: Traxxas Monster Truck forum
04-01-2008, 09:59 AM
Replies: 34
Views: 6,932
Posted By fellers

RE: o.s. .21 tm?

300 for a tiny little engine such as this is, just down right down right rediculous ! I paid 370 for my OS 91 SZ h-ph with perry fuel pump for my raptor 90 3d heli. This is a high end competition...
Forum: Traxxas Monster Truck forum
03-31-2008, 05:59 PM
Replies: 13
Views: 1,027
Posted By fellers

RE: Did I blow up the engine?

These engines really are not as fragile as you they (manufacturers) would have you think. Granted you have some sort of sense when operating it; and they are not a "High End"
race engine.
...
Forum: Traxxas Monster Truck forum
03-31-2008, 05:47 PM
Replies: 20
Views: 1,293
Posted By fellers

RE: What the hell is that noise?????

Sounds to me like you had a stone at one point stuck in between your clutch bell teeth and spur gear teeth. That gave you the groove in your spur gear teeth.
While that stone was in there it...
Forum: Traxxas Monster Truck forum
03-31-2008, 05:33 PM
Replies: 34
Views: 6,932
Posted By fellers

RE: o.s. .21 tm?

If it was not for the price I would have one now.
I'll just wait to someone gets board with thiers or OS stops being greedy :)
Forum: Traxxas Monster Truck forum
03-28-2008, 08:57 PM
Replies: 4
Views: 758
Posted By fellers

RE: Roll Center settings for revo 3.3

Nice. The tread looks to be perfect for the ravel pits and rock quarries i run in.
Question on the steering knuckles if ya don't mind. Are they supposed to be adjusted so there is no rocking...
Forum: Traxxas Monster Truck forum
03-28-2008, 08:15 PM
Replies: 4
Views: 758
Posted By fellers

RE: Roll Center settings for revo 3.3

hey Hillfinger, How do the badlands tire hold up beating them hard. They seem pretty flimsy. Key word being "seem". I have not tried these and am purely speculating and I hope I am wrong.
Forum: Traxxas Monster Truck forum
03-28-2008, 07:56 PM
Replies: 4
Views: 758
Posted By fellers

Roll Center settings for revo 3.3

Hey guys I am now installing my yellow died RPM arms all around the truck, ofna 17mm hub adaptors, pro line velocity 17mm 1/2" offset rims , and pro line badlands mt tire.

Is anyone mounting...
Forum: Traxxas Monster Truck forum
03-25-2008, 10:33 PM
Replies: 51
Views: 3,487
Posted By fellers

RE: Keep breaking headers!!!!

4-40 rod/piano wire
Forum: Traxxas Monster Truck forum
03-25-2008, 09:52 PM
Replies: 8
Views: 661
Posted By fellers

RE: Which Quality rims and Tires for bashing

ok gotcha. Thanks man.
Forum: Traxxas Monster Truck forum
03-25-2008, 09:36 PM
Replies: 8
Views: 661
Posted By fellers

RE: Which Quality rims and Tires for bashing

will it come off the side like hillfingers?
Forum: Traxxas Monster Truck forum
03-25-2008, 08:12 PM
Replies: 8
Views: 661
Posted By fellers

RE: Which Quality rims and Tires for bashing

What engine is on and pipe is your truck. Some more details please :)

How is the THS pipe from impakt. will it bolt right on the 3.3 and is it worth buying it?
Forum: Traxxas Monster Truck forum
03-25-2008, 07:37 PM
Replies: 8
Views: 661
Posted By fellers

RE: Which Quality rims and Tires for bashing

WoW! that thing is sweet! Nice job man, nice job... That tire setup is perfect with the hubs. Sold.
Forum: Traxxas Monster Truck forum
03-25-2008, 07:04 PM
Replies: 8
Views: 661
Posted By fellers

Which Quality rims and Tires for bashing

Hey guys I just went to A-main to look at some tires and rims to get for my revo strictly for beating it hard in gravel pits and rock quarries
. Problem is is that their is a million darn choices....
Forum: Traxxas Monster Truck forum
03-24-2008, 09:50 PM
Replies: 16
Views: 1,375
Posted By fellers

RE: Revo in the pool

Should not be any problem at all getting water in the engine; AS long as you flush it very good with a very generous amount of after run oil. Sandy gritty filthy water is a different story! I had a...
Forum: Traxxas Monster Truck forum
03-24-2008, 09:12 PM
Replies: 12
Views: 7,456
Posted By fellers

RE: Easiest way to change the revo 3.3 spur gear

We did it by pulling the engine and was very easy. Thanks guys.
My friends truck also turned out to have a toasted stock clutch in the clutch bell. His name is molsen3385 and he has a thread...
Showing results 1 to 25 of 354
 
Page 1 of 15
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.