RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: horsefeetky
Showing results 1 to 8 of 8
Search took 0.02 seconds.
Forum: RC Jets
01-11-2019, 04:16 AM
Replies: 2,625
Views: 737,419
Posted By horsefeetky

i would coat the bolt threads with wd40. then use...

i would coat the bolt threads with wd40. then use hysol glue into the hole with enough say 4cc/4ml then insert bolt a bit more into the wing than it would normally be when boom is bolted on. then...
Forum: RC Jets
02-07-2018, 06:46 PM
Replies: 2,625
Views: 737,419
Posted By horsefeetky

you may wish you had a 100n if off grass

you may wish you had a 100n if off grass
Forum: RC Jets
11-21-2017, 05:06 PM
Replies: 2,625
Views: 737,419
Posted By horsefeetky

i just us a bit of silicone caulk to hold mine in...

i just us a bit of silicone caulk to hold mine in place it is easy to pry loose if needed
Forum: RC Jets
10-08-2017, 09:52 AM
Replies: 2,625
Views: 737,419
Posted By horsefeetky

just posted my sport xcal for sale here if...

just posted my sport xcal for sale here if interested.. going with rebel with 140n for next year
Forum: RC Jets
09-23-2017, 02:31 PM
Replies: 2,625
Views: 737,419
Posted By horsefeetky

if you will update your tx to the new 1.20 i can...

if you will update your tx to the new 1.20 i can send you the spm file and it should load but i have had trouble with sharing files with telelmtry in use as it hangs up the other tx not knowing where...
Forum: RC Jets
09-23-2017, 02:29 PM
Replies: 2,625
Views: 737,419
Posted By horsefeetky

spektrum help.. hope the pics help you figure out...

spektrum help.. hope the pics help you figure out your setup and i use an ar8010t or 9310t rx's with telemetry on them and get info from the turbine and gps module to the tx and have speed report...
Forum: RC Jets
05-16-2017, 01:50 PM
Replies: 2,625
Views: 737,419
Posted By horsefeetky

my bet is that it is in the v2 or v1 solenoids i...

my bet is that it is in the v2 or v1 solenoids i have had one leak off before and it was in the programming and end points i had to set for the channel to get things to seal off right. cant put my...
Forum: RC Jets
02-28-2017, 04:37 AM
Replies: 2,625
Views: 737,419
Posted By horsefeetky

did you have the gear down checking this cg...

did you have the gear down checking this cg point...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.