RCU Forums - Search Results

Search: Posts Made By: shenlonco

Showing results 1 to 7 of 7
Search took 0.01 seconds.

Forum: RC Tanks

12-07-2016, 05:51 AM

Replies: 15

You guy's ever time your motors?

Views: 937

Posted By shenlonco

Stock tamiya 380 motors? how do they run compared...

Stock tamiya 380 motors? how do they run compared to the stock HL motors? faster more power or slower?
Thanks

Forum: RC Tanks

12-06-2016, 08:59 AM

Replies: 15

You guy's ever time your motors?

Views: 937

Posted By shenlonco

Guy's the motors used in these HL tanks are not...

Guy's the motors used in these HL tanks are not the same RPM I tested them on my RPM checker a long time ago and sometimes you just get a slower motor like with any electric RC motors some are faster...

Forum: RC Tanks

12-06-2016, 06:40 AM

Replies: 15

You guy's ever time your motors?

Views: 937

Posted By shenlonco

You know I was going to do a video for youtube...

You know I was going to do a video for youtube but I did not ... I knew i should have did one...maybe I will do one with a motor out of a tank just to show how to do it and post up the video in a new...

Forum: RC Tanks

12-06-2016, 06:09 AM

Replies: 15

You guy's ever time your motors?

Views: 937

Posted By shenlonco

I did it with all slot cars also and all RC...

I did it with all slot cars also and all RC stuff guess being in the RC and slot car hobby for over 35 years helps I just about seen everything! :D

Forum: RC Tanks

12-05-2016, 07:56 PM

Replies: 15

You guy's ever time your motors?

Views: 937

Posted By shenlonco

Try what i did ...take open 2 motor tabs with...

Try what i did ...take open 2 motor tabs with small screw driver and then simply push the pinion gear side in the motor so the plastic end bell pops open when holding it in your hand pop it off...

Forum: RC Tanks

12-05-2016, 05:20 PM

Replies: 15

You guy's ever time your motors?

Views: 937

Posted By shenlonco

Yea that's the way you could break the copper...

Yea that's the way you could break the copper windings because there not meant to be timed by twisting the com, turning the end bell is how they do it for rc motors same as these tank motors.it's...

Forum: RC Tanks

12-05-2016, 04:49 PM

Replies: 15

You guy's ever time your motors?

Views: 937

Posted By shenlonco

You guy's ever time your motors?

My walker bulldog was pulling way to one side no matter if i applied full trim so I took the slower motor out and bent up the motor tabs and ground off the plastic lump that sits in the notch on the...

Showing results 1 to 7 of 7