RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: mrbigg
Showing results 1 to 4 of 4
Search took 0.11 seconds.
Forum: Engine Conversions
12-29-2005, 05:03 PM
Replies: 347
Views: 55,707
Posted By mrbigg

RE: Who is converting Toro trimmers?

I was thinking of using one on smaller glow engines as well.
Forum: Engine Conversions
12-28-2005, 06:31 PM
Replies: 347
Views: 55,707
Posted By mrbigg

RE: Who is converting Toro trimmers?

in your video, i seen you use a drill for a starter. I'm assuming an 18 volt model. how did you make the "adapter" for the cone?
Forum: Engine Conversions
12-07-2005, 06:27 PM
Replies: 347
Views: 55,707
Posted By mrbigg

RE: Who is converting Toro trimmers?

Hi Dave. I used to have a 1.60 FX in it. I usually only used half throttle. I was running a Zinger 18x5 with the needle set at 8100. Do you think this motor will spin about the same rpm with this...
Forum: Engine Conversions
12-05-2005, 08:05 PM
Replies: 347
Views: 55,707
Posted By mrbigg

RE: Who is converting Toro trimmers?

I bet one of these would be great in my 1/4 scale Fokker DR1.
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.