RCU Forums - Search Results

Search: Posts Made By: e156642

Showing results 1 to 8 of 8
Search took 0.01 seconds.

Forum: Pattern Universe - RC Pattern Flying

05-09-2018, 02:06 PM

Replies: 25

Dualsky F3A motor

Views: 13,382

Posted By e156642

Yes I was running my motor on mid timing however...

Yes I was running my motor on mid timing however the instructions indicate this should be ok.

From manual below.
6. Timing:Low(0) / Medium(10) / High(20), default is Medium.
In normal cases, low...

Forum: Pattern Universe - RC Pattern Flying

05-09-2018, 02:31 AM

Replies: 25

Dualsky F3A motor

Views: 13,382

Posted By e156642

Speedracerntrixie, do you work for Dualsky?? ...

Speedracerntrixie, do you work for Dualsky??

I have been running electric F3A models since 2010, have had no issues with previous setups and NO motor failures until I tried Dualsky.
I currently...

Forum: Pattern Universe - RC Pattern Flying

05-08-2018, 02:33 AM

Replies: 25

Dualsky F3A motor

Views: 13,382

Posted By e156642

Dualsky have agreed to replace the rotor, however...

Dualsky have agreed to replace the rotor, however true to their form they haven't actually sent a replacement nor replied to my requests.

FAIL DUALSKY!!!!

Forum: Pattern Universe - RC Pattern Flying

04-26-2018, 02:42 PM

Replies: 25

Dualsky F3A motor

Views: 13,382

Posted By e156642

Timing

I connected the USB link to the Dualsky ESC model # XC10036HV to check the timing for you it is set to "Middle"

Forum: Pattern Universe - RC Pattern Flying

04-24-2018, 04:05 PM

Replies: 25

Dualsky F3A motor

Views: 13,382

Posted By e156642

Direct quote from Dualsky below “You...

Direct quote from Dualsky below

“You mentioned that you used PT 20x13, but if it's 3-blade propeller. The load was too much for XM6250DA-220KV. This maybe the reason.

The right setup is :...

Forum: Pattern Universe - RC Pattern Flying

04-24-2018, 03:59 PM

Replies: 25

Dualsky F3A motor

Views: 13,382

Posted By e156642

The issue is not with the motor you are running....

The issue is not with the motor you are running. This was actually my fault as the prop was too much load on this occasion.

Forum: Pattern Universe - RC Pattern Flying

04-24-2018, 01:31 AM

Replies: 25

Dualsky F3A motor

Views: 13,382

Posted By e156642

Setup used

Motor
XM6355DA-13
SN:170607-1 (tel:170607-1) 08

Speed Controller
XC10036HV default factory settings brake disabled

Propellor
PT 20x13EL (3 blade)

Forum: Pattern Universe - RC Pattern Flying

04-15-2018, 09:04 PM

Replies: 25

Dualsky F3A motor

Views: 13,382

Posted By e156642

Dualsky F3A motor

Thought I would try the new series of Dulsky motors. Was I WRONG.
I first purchased a XM6350DA-12 which I had no end of trouble with. I am running a Jetti spin 99 and couldn't go over 1/2 throttle...

Showing results 1 to 8 of 8