RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: bashking
Showing results 1 to 7 of 7
Search took 0.13 seconds.
Forum: RC Nitro Stadium Trucks
04-08-2005, 06:20 PM
Replies: 21,657
Views: 1,513,828
Posted By bashking

RE: Official HPI MT2 Thread

have a look at the nut on the side of the carb. It's the one that holds the rotating part on. If it is loose your car will still run but it rev up when you let go of the throttal and only idle...
Forum: RC Nitro Stadium Trucks
03-27-2005, 06:25 PM
Replies: 21,657
Views: 1,513,828
Posted By bashking

RE: Official HPI MT2 Thread

46U i wasn't haveing a go i was just saying that these things happen sometimes. I know i treat my cars well and try not to break them needlessly but i just find the rotostarts easier. Some people...
Forum: RC Nitro Stadium Trucks
03-27-2005, 05:56 AM
Replies: 21,657
Views: 1,513,828
Posted By bashking

RE: Official HPI MT2 Thread

We seem to have this kind of coversation quite often. I have accused people of misusing equipment causing it to break i.e spurs, rotostarts. I can assure you i have tried my hardest to baby the...
Forum: RC Nitro Stadium Trucks
03-26-2005, 08:08 PM
Replies: 21,657
Views: 1,513,828
Posted By bashking

RE: Official HPI MT2 Thread

I have spent the last month converting all my rotostart engines into pullstarts cus the rotostart was doing my head in (basically i got bored of charging the batteries and one of my rotostarts chewed...
Forum: RC Nitro Stadium Trucks
03-21-2005, 07:13 PM
Replies: 21,657
Views: 1,513,828
Posted By bashking

RE: Official HPI MT2 Thread

Thanks buddy i will get straight on it.

I love these forums everyone is so helpfull and.....sniff sniff................. I LOVE YOU GUYS!!!!!

(Not that kinda love) you know what i mean!
Forum: RC Nitro Stadium Trucks
03-21-2005, 06:45 PM
Replies: 21,657
Views: 1,513,828
Posted By bashking

RE: Official HPI MT2 Thread

Thanks for the quick reply. Just to clarify the point do you mean i should run a flanged bearing on the inside of the clutch housing then 2 normal bearings in the middle and than another one of the...
Forum: RC Nitro Stadium Trucks
03-21-2005, 06:23 PM
Replies: 21,657
Views: 1,513,828
Posted By bashking

RE: Official HPI MT2 Thread

Hi guys.

I have a problem and a question.
The problem is that my 18ss has chewed up the crappy little needle bearing in the clutch bell (part b046) it's the bearing that sits between the...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.