RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: Jaketab
Showing results 1 to 25 of 267
Search took 0.19 seconds.
02-22-2024, 05:21 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Jason, Have you contacted a CARF representative...

Jason,
Have you contacted a CARF representative to see if they could fill your order for a Moki180?
Last June/2023 I ordered Moki parts directly from Airworld and also directly from Jim Baker who...
02-12-2024, 06:23 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Contact Brendon at Just Plane Crazy. He just...

Contact Brendon at Just Plane Crazy. He just posted newly completed video of at TRC T-28 with a UMS180. His Face Book page and You Tube channel are: Just Plane Crazy.
Airworld.de is the worldwide...
02-10-2024, 09:22 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

When I was refilling the gear housing with gear...

When I was refilling the gear housing with gear oil, I found it dissipating somewhere. It required refilling about twice per flying season. Having replaced the front bearing, repacked with blue...
01-13-2024, 07:59 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

The carb on my 250 is the Wabro 225B, 837. I'm...

The carb on my 250 is the Wabro 225B, 837. I'm going to take a wild guess and say after 11 years it might be time for a little maintenance.
QUESTION - Is the correct gasket kit Walbro part #...
01-03-2024, 06:35 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Detlef, Yes, I noticed that the piston is...

Detlef,
Yes, I noticed that the piston is offset. I've already experimented with reinstalling it.
I'm thinking of omitting the piston for 3 reasons.
1. I use the electric pump.
2. The piston...
01-02-2024, 04:46 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Detlef, Your advice was spot on the mark. My...

Detlef,
Your advice was spot on the mark.
My first attempt I used propane to heat the case. The bearing could not be extracted.
Second attempt, I heated the front case (with bearing) in the oven...
12-28-2023, 05:48 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Detlef, sorry for the confusing paragraph. I...

Detlef, sorry for the confusing paragraph. I removed the top gear only after marking the tooth location as it merges with the shaft and replaced it in the exact location. I discovered the gear...
12-27-2023, 12:34 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Detlef - Thank you. Before I removed the...

Detlef - Thank you. Before I removed the planetary gears completely, I marked a point on the top gear where it merged with the shaft to prevent getting the gear out of sync. The shaft was positioned...
12-26-2023, 06:05 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Moki 250 Front Grease

My older Moki 250 (about 2010) had hundreds of flights. Today was the day (1st time) to pull the front gear case to inspect and replace the cam and gears. For the past 3-4 years I've been injecting...
09-21-2023, 09:07 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Gentlemen, 2 things to comment on regarding the...

Gentlemen, 2 things to comment on regarding the last few posts for those who are new to Moki. When attempting to start a Moki, or any like engine, upon 2nd or subsequent starting, many times the...
07-01-2023, 06:33 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Detlef - thank you for the advice. Yes, my...

Detlef - thank you for the advice. Yes, my concern is getting the planetary gears off by 1 tooth.
I have 2 - 250's and have been running the pump from the beginning.
In the older Moki with...
06-25-2023, 04:17 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

The Moki video series by Olivier Rogeau are a...

The Moki video series by Olivier Rogeau are a must watch for Moki owners. The videos are spoken in French, but still easy to follow. Video #5 shows the reassembly of the cam ring and planetary gears....
06-24-2023, 05:00 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Looking for some guidance to repack the front...

Looking for some guidance to repack the front gear case on a Moki 250. The engine is down for repair, and this would be the optimum time to inspect the planetary gears and cam ring. A friend recently...
06-20-2023, 05:13 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Hello, I'm in need of a motor mount for a Moki...

Hello,
I'm in need of a motor mount for a Moki 250. Plane was involved in a crash, but fortunately the only damage to engine was loss of 3 pushrods and a broken rear motor mount.
Please PM if you...
04-03-2023, 11:48 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

FYI. Just passing on some prop rpm data. ...

FYI. Just passing on some prop rpm data. Finally able to get outside tune up and test run my 12-year-old Moki 250 today. I recorded the rpms of 5 different props. Unfortunately, I did not have a...
03-29-2023, 08:59 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Thanks. Just found out that Ray Labonte/ CARF...

Thanks. Just found out that Ray Labonte/ CARF has limited supply in stock now. Ordered a 32 x 18.

J Tab
03-08-2023, 05:20 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Question - Now that there is no longer a source...

Question - Now that there is no longer a source for SEP props in the USA, what brand and source of wood props is a good match for Moki 250 and 300.
I liked the SEP props because they placed a...
02-05-2023, 12:18 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

wphilb - Thanks for providing the Moki service...

wphilb - Thanks for providing the Moki service contact information. Been waiting a while to order some parts.
Where did you send your 150 for service? It appears Mr. Baker's will have 2 different...
10-21-2022, 11:32 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Hello Steven, I read from your post that you...

Hello Steven,
I read from your post that you tried another ignition module with no success.
Do you have access to a new or another Hall Sensor Cable???
That would be the easiest to try before...
10-16-2022, 01:36 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Have you tried a new hall sensor cable? The very...

Have you tried a new hall sensor cable? The very small wiring in these is very fragile and is a known weak point.
When mine was bad, the red light on the ignition module showed power but the green...
09-28-2022, 10:05 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Just came across some a very excellent Moki...

Just came across some a very excellent Moki information source. Olivier Rogeau of France has a business named, "Modelisme Micromoteurs Service". He has begun posting a series of videos of a Moki 250...
08-13-2022, 06:53 AM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Question please. Will the older black "Top Hat"...

Question please. Will the older black "Top Hat" 6v ignition module from a Moki 250 be compatible with a Moki 400?
A friend has a 400 with the older ignition and needs to test to determine if his...
07-24-2022, 03:20 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

I have been using 100LL AV gas for the last 5...

I have been using 100LL AV gas for the last 5 years. Mixed with Amsoil Dominator 45/1 and 1 oz Seaform per gallon. Use the AV gas in both Moki 250's and Valach 210. At the end of each flying...
07-18-2022, 01:31 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

This just came across on FB. CARF is now USA...

This just came across on FB.
CARF is now USA distributor for MOKI Sales and Service....
07-12-2022, 03:12 PM
Replies: 5,152
Views: 1,361,435
Posted By Jaketab

Mike - The info you relayed is exactly on point...

Mike - The info you relayed is exactly on point from what I was privileged. Also told that announcements may be very soon.
J Tab
Showing results 1 to 25 of 267
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.