RCU Forums - Search Results

Search: Posts Made By: mhpverheggen

Showing results 1 to 6 of 6
Search took 0.01 seconds.

Forum: JetCat Turbine Direct Support

11-27-2020, 11:43 AM

Replies: 11

P300rx

Views: 3,479

Posted By mhpverheggen

Ah ok. When it first appeared I was not able to...

Ah ok. When it first appeared I was not able to start the engine. After I did the “procedure” it worked again.

Thanks for your help Dave.

Forum: JetCat Turbine Direct Support

11-27-2020, 08:41 AM

Replies: 11

P300rx

Views: 3,479

Posted By mhpverheggen

Hi Dave, im not familiar with “OC”?

Hi Dave,

im not familiar with “OC”?

Forum: JetCat Turbine Direct Support

11-27-2020, 08:11 AM

Replies: 11

P300rx

Views: 3,479

Posted By mhpverheggen

It is fixed. I had to reprogram the unit for fuel...

It is fixed. I had to reprogram the unit for fuel pump and do an engine start. (Hold the “change value” during electrical power-up. Select “fuel pump”. The “no pump” message remains until you do an...

Forum: JetCat Turbine Direct Support

11-26-2020, 04:46 PM

Replies: 11

P300rx

Views: 3,479

Posted By mhpverheggen

It might be jammed, I’ll have to check. I did try...

It might be jammed, I’ll have to check. I did try the prime function but no luck. The green light on the pump is on though so it does receive power I assume?

Forum: JetCat Turbine Direct Support

11-26-2020, 10:36 AM

Replies: 11

P300rx

Views: 3,479

Posted By mhpverheggen

Yes I did, it appeared when I wanted to start...

Yes I did,
it appeared when I wanted to start the engine for the 3th flight of the day. Bat voltage was good.
could it be that it has an issue with the little “motherboard” in the pump?

Forum: JetCat Turbine Direct Support

11-26-2020, 10:19 AM

Replies: 11

P300rx

Views: 3,479

Posted By mhpverheggen

P300rx

I got the “no pump” message. According the manual it means no pump connected or a defective pump cable. I tried with a new pump cable with no luck.
Anybody has any idea what else could it be?

Showing results 1 to 6 of 6