RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: rmh
Showing results 1 to 17 of 17
Search took 0.09 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-23-2011, 02:37 PM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

This certainly is not going well- If one has access to a goosd scope - won't the information transfer arrangement be apparant?
I don't have a scope - except for some Scope in a bottle to...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-22-2011, 06:03 AM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

there you go- ! Probably HiTech and others have similar Q&A sites -
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-22-2011, 03:53 AM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

There is a lot of info on those pages in the Spektrum RC site -and much of it applies to 2.4 in general.
Why argue or doubt when the info is readily available -if one is interested in the ...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-21-2011, 07:18 PM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

http://www.spektrumrc.com/Articles/Article.aspx?ArticleID=1789
I thot this was common knowledge at this point in time .
apparantly others as well as you - didn't know about this.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-21-2011, 02:29 PM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

When I said "purpose built" - I meant -new tx technology -not an add on setup
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-21-2011, 12:34 PM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

Here is where the fit hits the shan:
using a high torque servo( high power req'd), the old Y connector is not a great setup.
also reversing a servo (actually getting inside it and...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-21-2011, 11:19 AM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

No it will not
The internal wiring of the dedicated 2.4 TX is a big part of this . You can however select two closer channels and mix the elevator to reduce the problem
I had a 9- -It...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-21-2011, 11:00 AM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

I wuz surprised - I thot he mentioned he had a DX7 and a scope!
In that I simply copied the info available to anyone with a computer - Iwas surprised others had not mentioned it was common...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-21-2011, 09:24 AM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

just go to the SPEKTRUMwebsite
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-21-2011, 03:22 AM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

"If they have this available in the 12FG then there is a good possibility that other Futaba radios or even JR/Spektrum radios may have this enhancement." end quote

The info I posted inc the ...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-20-2011, 07:13 PM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

Those fuselages were built in two pieces attached at the canopy.
I did them that way in order to fit the work benches .
They were simply enlarged versions of the ones I did for Steve Rojecki...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-20-2011, 04:42 PM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

Zor I thot you may be a bit more comfortable with this info:The first oscilloscope photo shows the R921 2.4GHz receiver’s elevator channel (top ) and auxiliary no. 3 channel (bottom). The pulses...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-20-2011, 11:51 AM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

thot we went thru this before -a while back
2.4 does NOT have to be sequencial
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-20-2011, 07:22 AM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

really NONE of the current 2.4 g txs should have much of this type problem-
The super duper txs for heli use with optomized servos etc., will be best -but on fixed wing - any 2.4 should...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-20-2011, 03:30 AM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

The elevator errors caused tracking problems on the model
This is one of the cases where you have to have "been there".
It's like having a guitar which has a bad neck setup - you can...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-19-2011, 05:59 PM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

IF one has spent lots of time sorting out competition setups - dual elevs mixed controls -(not to tmention helicopter lag problems)
The idea that tx lead /lag is not important or...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-18-2011, 05:21 AM
Replies: 85
Views: 5,336
Posted By rmh

RE: 9C elevator tracking

The lag argument is real - and really noticable -
The JR10X had the same problem -as did any of the early systems
When I got my DX7- I had to readjust expos to get same feel on the...
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.