RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: wojtek
Showing results 1 to 25 of 42
Search took 0.21 seconds.
Forum: RC Jets
01-19-2014, 10:28 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

I find the sets Dreamworks sells to be far better...

I find the sets Dreamworks sells to be far better in quality and function. Maybe these were not from a Flash set that were used ? those wheels in that one post really come short of clearing the...
Forum: RC Jets
12-19-2013, 11:56 PM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

I agree with Dave here ... the ducting is nice,...

I agree with Dave here ... the ducting is nice, but not absolutely needed. Keep the carbon cover however. Its good to shield off the hot section back there . As for the bottom cover ( bottom of plane...
Forum: RC Jets
12-11-2013, 09:10 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

I have a spare UFwing, however it is slightly...

I have a spare UFwing, however it is slightly charred at the center section. I had a fire in the air and the rear of the plane burned off. The wing is structurally sound however. I also have an...
Forum: RC Jets
10-15-2013, 08:13 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

from experience, i find that the tanks drain best...

from experience, i find that the tanks drain best when pulling from wing tank first, then fuselage tank second. Its also a neater set up and allows you to run the vent out of the bottom of the wing...
Forum: RC Jets
08-19-2013, 06:57 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

Alan DeLena is ... and looks to be working...

Alan DeLena is ... and looks to be working awesome.. electric brakes as well ! A single battery charge seems good for a whole weekend of flying with no recgarging needed . If i had not already had...
Forum: RC Jets
08-10-2013, 06:34 PM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

Hey Guys, for anyone looking for a a cockpit...

Hey Guys, for anyone looking for a a cockpit dash and parts, these are not available on our site :)

http://shop.all-scale.com/cockpitinstrumentpanels.aspx

...
Forum: RC Jets
12-17-2012, 10:51 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

Has anyone found the saddle tanks to being prone to cracking / leaking ? The ones I had ( used for smoke) needed to be reinforced a bit.

~V~
Forum: RC Jets
12-13-2012, 05:27 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

no it doesn't !! ...


lol, j/k !!


~V~
Forum: RC Jets
12-12-2012, 04:00 PM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

Crow is not about adding drag as much as it is about reducing lift. If lift is reduced by a certain margin, this leaves a more positive feeling on landing, and a larger speed envelope to perform...
Forum: RC Jets
12-11-2012, 08:42 PM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

I found my UF landed best with Crow. I actually needed it with the residual thrust off of my Rhino, otherwise it floats on and on .. I can't wait to get my 2nd flash in the air.

Under or...
Forum: RC Jets
10-09-2012, 09:13 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

wow, that looks great ! Best military finish on a sport jet I have seen in a long time [8D]

~V~
Forum: RC Jets
10-09-2012, 08:31 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

Well, im soon about to start on UF #2 :\ ... Still not sure what caused the fire. I went up, and rudder servo kept pulling hard over .. I later found out it was melting .. I landed the plane and...
Forum: RC Jets
10-03-2012, 06:49 PM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

The JC Rhino has a FOD screen on it and the frame blocks off a lot of the gap at the inlet between the bypass. These cheater holes allow the bypassed area to suck more air in if needed. This also...
Forum: RC Jets
10-03-2012, 04:33 PM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

Man, this was a tight fit !, but i have the smoke tanks in WITH the full bypass :) .. The intake duct had to be ground down at the side lip, and them i rejoined it with some carbon cloth. After all...
Forum: RC Jets
07-17-2012, 05:51 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

I have a 36lbs turbine in my UF, and at any speed and any thrust, the plane is dead on straight with no trim changes whatsoever. If it climbs under power, i would check and or a combination of the...
Forum: RC Jets
05-17-2012, 09:32 PM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

I run a 170 as well, fully bypassed and with FOD . No problems at all :) ... You can also cut a few round holes in the bypass cover both forward of the intake and slightly behind the lip of the FOD...
Forum: RC Jets
12-26-2011, 05:04 PM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

Hi Ali,

so how much flap do you use with the 6mm crow ?

Voy
Forum: RC Jets
12-21-2011, 07:28 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

agree 100% ... the fuel will follow the path of least resistance, sp poking a hole in it, negates the function of the felt clunk ..

The fuel pump has incredible suction and should not be...
Forum: RC Jets
12-20-2011, 08:42 PM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

I'm using a 36lbs Jet Central Rhino sucking fuel up through the felt clunk ... no problems at all ..


~V~
Forum: RC Jets
10-23-2011, 05:06 PM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

+2 ... When turning and burning, full blow of a 160 size engine comes in handy just to maintain speed through continuous high G manouvers where speed bleeds off very quickly ... its more about...
Forum: RC Jets
10-05-2011, 08:45 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

lol ... stir away :D ..


how much flap are you using ? im still playing around with my throws ...


~V~
Forum: RC Jets
10-05-2011, 04:32 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

@bigbri the UF will snap pretty well .. not a blur fast not a lighting fast blur of a snap, but it will snap nicely. recovery is effortless. Nose drops out on its own ... similar with spins , but...
Forum: RC Jets
10-04-2011, 05:17 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

Yes, the UF will fly fast on most power .. 17 - 37 lbs .. all good .. but its about how quickly it gets up to speed, how fast it will climb vertically ( or not :D ) and also when pulling through...
Forum: RC Jets
10-03-2011, 04:32 PM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

http://www.carf-models.com/public_carf/pages/shop/accessoryDetail.html?root=accessory&proId=2772

I'm not sure on the exact capacity, but I'd say definitely around 24oz or more per tank ... And...
Forum: RC Jets
10-03-2011, 09:45 AM
Replies: 6,824
Views: 1,673,044
Posted By wojtek

RE: C-ARF Ultra Flash build Thread + Video

Check out what Shui ( www.shulmanaviation.com ) hooked me up with [8D] ..

these are the new smoke/fuel saddle tanks from CARF for the Flashes ( regular and UF)

Its a super tight fit, but...
Showing results 1 to 25 of 42
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.