RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: CoosBayLumber
Showing results 1 to 1 of 1
Search took 0.10 seconds.
Forum: Tips & Techniques
08-27-2006, 10:00 AM
Replies: 6
Views: 871
Posted By CoosBayLumber

RE: 3/4" hole in Balsa? How?!

I have used large diameter end mills with four or more flutes. Chuck them up into a drill press, run as high RPM (2000+) as possible before tounching down to cut a hole. Sharp ones can be found at...
Showing results 1 to 1 of 1


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.