RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: mikeang
Showing results 1 to 23 of 23
Search took 0.09 seconds.
Forum: Electric RC Helis
11-26-2007, 05:19 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Hi all.
My heli is vibrating during flight. What things should i check for to solve the vibration problem?
I have to say that i installed new main blades and didnt balance them, how do you...
Forum: Electric RC Helis
11-16-2007, 03:27 AM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Hi. I think that i passed the end point of the 4in1 setup pot, i turned it to the right and it dont stop nowhere.
How many degrees should be turned without breaking it?

Mike
Forum: Electric RC Helis
07-19-2007, 05:26 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Hi Boyrazalo,
Maybe your tail motor is failing down, try with a new tail motor and there is a big chance the yaw problem to be cured.

Mike
Forum: Electric RC Helis
07-18-2007, 02:00 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

I put a normal length of flybar, in later time i will try the shortened flybar.Hope i dont crash hard again; this nose-in hovering requires total concentration!

Mike
Forum: Electric RC Helis
07-15-2007, 03:03 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Hi,
Due to a crash i had to cut short the flybar rod.The length of the flybar is now 5.9 inches. How this will affect the cyclic? I have a spare flybar, but i want to know if the heli is...
Forum: Electric RC Helis
05-18-2007, 04:51 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Jet hobby has wooden blades for our FP heli, and in stock. http://www.jethobby.com.sg/cgi-bin/ezsite/prod/manager.cgi?action=show&pid=863&cid=5&idx=1

Mike
Forum: Electric RC Helis
04-20-2007, 11:54 AM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Thanks mrasmm. Thats a quick and cheap solution ;)

Mike
Forum: Electric RC Helis
04-20-2007, 11:52 AM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum
Forum: Electric RC Helis
04-20-2007, 05:45 AM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Speaking about motors, is there a more powerfull motor than the stock, which can be handled from the stock Nimh pack?

I have found a more clear exploded view of the heli.Its the DF4's view.

...
Forum: Electric RC Helis
04-19-2007, 05:34 AM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Thanks mrasmm.
It must be a shorted core. When the motor worked for 1st time, i noticed sparks coming out from the holes. Next time i will follow your intructions about the break-in method. Great...
Forum: Electric RC Helis
04-18-2007, 12:50 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

A week ago i replaced the main motor. After each flight the motor gets very hot.The old one didnt got so hot. I replaced 4 times the motros and never used the break-in method,just i installed it and...
Forum: Electric RC Helis
03-21-2007, 01:47 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Hi.

I am considering going brushless on my F40. Can someone of you guys recommend a good combo of the parts that i will need?
And also from where i can order them.

Thanks.
Mike
Forum: Electric RC Helis
03-10-2007, 01:45 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

I just had a servo problem too.

While i was flying, the elevator servo stopped responding following a crash.

I checked it with a fresh battery, and still the servo is not responding.Also it...
Forum: Electric RC Helis
03-06-2007, 11:49 AM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

[quote]ORIGINAL: mikeang

Hi.

The nose of my F40 cant keep straight, it yaws to the left.If i try to correct it with a right trim, then it yaws to the right. How can i solve this?


...
Forum: Electric RC Helis
02-23-2007, 01:51 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Hey Robotronski,

I wish to you good luck! Hope that you overcome all the difficulties and become a distributor of this loveable heli.

Mike
Forum: Electric RC Helis
02-17-2007, 03:15 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Riggerbill,

C, is standing for capacity. Your pack has 600mah capacity.

Check this out with good info about batteries: http://www.batteryuniversity.com/

Mike
Forum: Electric RC Helis
02-17-2007, 01:39 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Hi.

The nose of my F40 cant keep straight, it yaws to the left.If i try to correct it with a right trim, then it yaws to the right. How can i solve this?

Riggerbill, the max charge rate for...
Forum: Electric RC Helis
02-05-2007, 05:56 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

I found an exploded view, not of the DF40, but of the Sabre heli which i believe its the same as our heli. Most probably you already fixed it, but here it is for future reference.
Forum: Electric RC Helis
12-18-2006, 03:49 AM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

TitaniumZX, thanks for your helpful reply.

Mike
Forum: Electric RC Helis
12-17-2006, 04:04 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Hi.

I am using the supplied NiMh packs for my F40, and i was wondering how deep should i discharge them.

What i do, when my heli has not enough power to stay on the air, i take it in my...
Forum: Electric RC Helis
12-06-2006, 11:52 AM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Hi all.

On the supplied transmitter i noticed that after some uses the throttle trim needs to go more up to make the main motor start spinning.This is about at 3/4 of throttle trim and little...
Forum: Electric RC Helis
10-21-2006, 06:10 AM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Robotronski.Thanks for the reply.

Everytime i am checking the flybar paddles to ensure that they are in the correct position.

U said that maybe i bend the main shaft; i forgot to mention an...
Forum: Electric RC Helis
10-20-2006, 05:02 PM
Replies: 9,618
Views: 909,113
Posted By mikeang

RE: Falcon 40 (Exceed heli) Forum

Hello to everybody.
I am glad to found that there is a Falcon 40 forum.

I have this heli for 2 months and i also love it.

Many times i can hover pretty well, but still i am newbie and...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.