RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: dmyers0403
Showing results 1 to 17 of 17
Search took 0.03 seconds.
05-07-2015, 12:54 PM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

FYI: Just a note to those using the EME70 with...

FYI: Just a note to those using the EME70 with starter. Both of mine had the same problem with intermediate spur gear in the starter system at initial start. The motor started to turn over in proper...
01-12-2015, 07:57 AM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

Back to re-work on friends Zero with EME70...

Back to re-work on friends Zero with EME70 w/Starter. Cowl is 9-7/8" Diam. as mentioned earlier. Plugs will protrude slightly. Will post pics on cowl cutouts soon but working on top tray and cowl...
12-17-2014, 09:25 AM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

Plug caps would stick out for sure with the...

Plug caps would stick out for sure with the DLE111 but you would have one Helluv a monster "Hang On for the Ride".
EME70 Caps would fit easily and the starter is neat but there is also a starter...
12-17-2014, 07:14 AM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

Yes - This TBM Zero had 4.5 Degrees of Right...

Yes - This TBM Zero had 4.5 Degrees of Right Thrust (wow) and 2.5 Down Thrust which is considerable more (about twice as much) than I typically use. I decided to keep the stock setup since it has...
12-17-2014, 06:12 AM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

Unhappy PERFECT !!!! Dang-it - Now I want the FW-190. I...

PERFECT !!!! Dang-it - Now I want the FW-190. I need to quit reading these threads -- it does my addiction no good.
12-16-2014, 09:12 PM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

A Target :rolleyes:

A Target :rolleyes:
12-16-2014, 08:47 PM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

The CRRC-55 twin could be a good fit, its a great...

The CRRC-55 twin could be a good fit, its a great running engine unless you need goobs of power. The CRRC turns 20/10 very well.
12-16-2014, 08:38 PM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

Actualy the left cap will clear but the right...

Actualy the left cap will clear but the right will not due to engine center offset. The blister would need to be at lower sides of cowl. Front view shows lower angled position of plugs. I could...
12-16-2014, 08:04 PM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

Thought I would post a few pics of the EME70 twin...

Thought I would post a few pics of the EME70 twin with factory starter that I am installing on my friends TBM Zero to replace ZDZ80 single. Not to hijack the thread but to help answer earlier...
12-12-2014, 07:02 PM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

I use a 3S-1300mah and it last several starts,...

I use a 3S-1300mah and it last several starts, enough for a full day with plenty to spare. Standard engine stand offs are same as used on non starter version and need some spacers to allow gear bolt...
12-11-2014, 07:28 PM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

The EME70 is a sweet engine. Bought mine from...

The EME70 is a sweet engine. Bought mine from Milehigh with starter installed. Installed on 96 inch AMR-RC stick to replace DLE50. Ran perfect out of box. Very smooth with great throttle transition....
06-05-2014, 04:34 AM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

I use Hysol a lot but Hysol has its certain...

I use Hysol a lot but Hysol has its certain application for fillits, voids etc but is not for everything. Thinner better penetrating epoxies should be used where tighter joints, clamping are needed...
04-28-2014, 04:27 AM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

Servo choke on mine also, works great. As for...

Servo choke on mine also, works great.
As for as installing the electric start--I assume you modified a DL type engine? If I recall correctly they furnished a new hub and bolt with a modified keyway...
04-27-2014, 04:38 PM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

Torn between getting this FW190 or the P40,...

Torn between getting this FW190 or the P40, decisions-decisions, but I am concerned about how well the gear will hold up on the FW but know the P40 gear is very tuff. Opinions !!??
Leaning to the...
04-27-2014, 04:30 PM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

Per my earlier post == I use 3S-800mah and I do...

Per my earlier post == I use 3S-800mah and I do need the choke for cold starts. Switch will not let engine turn but a few revolutions each time so I believe you will need to choke no matter what....
04-25-2014, 11:43 AM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

What is cowl diameter couple inches from front?

What is cowl diameter couple inches from front?
04-23-2014, 12:43 PM
Replies: 4,698
Views: 832,949
Posted By dmyers0403

For what its worth I have the starter on my old...

For what its worth I have the starter on my old DL50 with a 800mah 3S installed on a AMR-50 stick for everyday flying and it will start all day with plenty to spare after a dozen or more starts. So...
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.