RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: cathurga
Showing results 1 to 7 of 7
Search took 0.02 seconds.
Forum: Gas Engines
01-06-2020, 08:45 PM
Replies: 226
Views: 91,559
Posted By cathurga

Hey All, Again, its been a while since...

Hey All,

Again, its been a while since posting, but life ha got in the way of my hobby!

Fired the engine up again after looking into the valve timing, and resetting it as I thought it might be...
Forum: Gas Engines
12-08-2019, 10:08 PM
Replies: 226
Views: 91,559
Posted By cathurga

Does anyone know whether OS used Rcxel CDI tech...

Does anyone know whether OS used Rcxel CDI tech when building the Ignition module? I am trying to figure out whether the curve is different to othe modules. I saw a thread once (not here, by the...
Forum: Gas Engines
12-08-2019, 11:28 AM
Replies: 226
Views: 91,559
Posted By cathurga

Appreciate the offer, and may take you up on it....

Appreciate the offer, and may take you up on it. I was thinking of putting your elbow, and then a flex pipe. I think OS do a 15x1mm flex pipe. Your elbow is 16x1mm male, and 15x1mm female side right?
Forum: Gas Engines
12-08-2019, 12:14 AM
Replies: 226
Views: 91,559
Posted By cathurga

Well its been a while since posting here, and I...

Well its been a while since posting here, and I have eventually managed to get the engine mounted on a test stand......but its not all plain sailing...

AA5BY, firstly to respond to your comment...
Forum: Gas Engines
11-08-2019, 01:36 AM
Replies: 226
Views: 91,559
Posted By cathurga

Does anyone know what the thread is of the...

Does anyone know what the thread is of the exhaust pipe fitting? I am looking to but a right angle and then find out whether any of the OS flex pipes will fit on it. But I need to find the thread...
Forum: Gas Engines
08-30-2019, 11:53 AM
Replies: 226
Views: 91,559
Posted By cathurga

As confirmed by "the pope", that stop screw is...

As confirmed by "the pope", that stop screw is indeed, a left hand thread. I got it off without too much of a fight, but when replacing, should I put some loctite on it, or is that a waste of time?
Forum: Gas Engines
08-29-2019, 11:04 AM
Replies: 226
Views: 91,559
Posted By cathurga

Hey all, I was given one of these engines by...

Hey all,

I was given one of these engines by a fellow flyer, he did something really bad with it, and it means to get it running I need to spend around $250 on it to get it right again. One of the...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.