RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: DR10044
Showing results 1 to 6 of 6
Search took 0.09 seconds.
Forum: Glow Engines
04-02-2007, 10:59 PM
Replies: 2,331
Views: 322,388
Posted By DR10044

RE: *** CLUB SUPER TIGRE ***

Not24, I used a 14x6 to break the engine in on my test stand. I ran it tonight mounted on the plane for the first time with the same prop and it runs great. I am still running it rich and it has...
Forum: Glow Engines
04-02-2007, 02:39 PM
Replies: 2,331
Views: 322,388
Posted By DR10044

RE: *** CLUB SUPER TIGRE ***

I use idle bars too. I don't know how much you tend to lose on the high end (is there an average?) but most people tend to over power their planes anyway so I have never found it to be an issue.
Forum: Glow Engines
04-02-2007, 10:06 AM
Replies: 2,331
Views: 322,388
Posted By DR10044

RE: *** CLUB SUPER TIGRE ***

What prop would you recommend for a ST90 on a Goldberg 67" 540 Edge? I have a Slimline inverted pitts muffler. The engine is new. I have ran 8 tanks of fuel through it on my test stand. Runs...
Forum: Glow Engines
03-15-2007, 10:24 AM
Replies: 2,331
Views: 322,388
Posted By DR10044

RE: *** CLUB SUPER TIGRE ***

I just got off the phone with SuperTigre service, they said the drive washer and locking cone both have to be replaced. The parts will cost less than $10. The way they talked it must be a comon...
Forum: Glow Engines
03-15-2007, 08:20 AM
Replies: 2,331
Views: 322,388
Posted By DR10044

RE: *** CLUB SUPER TIGRE ***

My st90 is about 8 years old. In the manual the back of the prop sits on the "rear drive washer". The rear drive washer sits on the locking cone. The problem I have is rear drive washer is...
Forum: Glow Engines
03-14-2007, 10:01 PM
Replies: 2,331
Views: 322,388
Posted By DR10044

RE: *** CLUB SUPER TIGRE ***

My SuperTigre 75's rear drive washer slips whenever I try to tighten or remove the prop. I have to use vice grips to keep it from slipping. How do I fix this? Is it a sign of a larger problem? ...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.