RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Roguedog
Showing results 1 to 5 of 5
Search took 0.07 seconds.
10-03-2011, 08:03 PM
Replies: 806
Views: 125,124
Posted By Roguedog

RE: Another Blue Angel build

dhal22,

I would suggest either using a needle to poke a bunch of wholes in the the aileron or sanding off one side of the aileron then wet it with water or ammonia, then apply the heat so it...
05-28-2011, 09:47 PM
Replies: 806
Views: 125,124
Posted By Roguedog

RE: Another Blue Angel build

Hey David,
Was catchin up on the thread.

If you have one of Nelson's Hanno P&L sets I don't think it will work on a 61SF or 61SF-P as they were made for the Hannoversion of the 61RF. They will...
02-13-2011, 08:58 PM
Replies: 806
Views: 125,124
Posted By Roguedog

RE: Another Blue Angel build

David,

How about afiberglass shim? You could place some epoxy and 3/4 oxz cloth either right on firewall or lay it out on a piece of mylar let it harden then trim to fit. You could add thin strips...
02-11-2011, 11:26 PM
Replies: 806
Views: 125,124
Posted By Roguedog

RE: Another Blue Angel build

David,

Sorry it did not work you.

I've had to add the washer on several of my engines because the later replacement thrust plates rubbed on the crankcase when tighting the prop...
02-06-2011, 12:34 AM
Replies: 806
Views: 125,124
Posted By Roguedog

RE: Another Blue Angel build

Hey David,

Add another thrust washer behind the drive plate or if you have an Old 61 FSR swap the FSR drive plate for the SF drive plate. The FSR drive plate is a little thicker and does not use...
Showing results 1 to 5 of 5


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.