RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: lsurber
Showing results 1 to 3 of 3
Search took 0.08 seconds.
Forum: Car Nitro & Gas Engines
09-27-2007, 05:05 PM
Replies: 73
Views: 21,669
Posted By lsurber

RE: Induction Timing

No, I don't do all that stuff, just eyeball it and work slowly!!!! LOL!!!!;)
Forum: Car Nitro & Gas Engines
09-27-2007, 04:19 PM
Replies: 73
Views: 21,669
Posted By lsurber

RE: Induction Timing

If you measure the incidence angle of the port and sleeve wall thickness then use the law of sines you can determine where to transcribe the line!

SinA/a = SinB/b =SinC/c

Note: A and B...
Forum: Car Nitro & Gas Engines
09-27-2007, 01:25 PM
Replies: 73
Views: 21,669
Posted By lsurber

RE: Induction Timing

Once you have crank position locked for your new timing marks measure depth from top of sleeve to top of piston. Next, transfer the inside measurement to the outside of the sleeve, mark with scribe,...
Showing results 1 to 3 of 3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.