RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: simplecj
Showing results 1 to 25 of 289
Search took 0.11 seconds.
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

I'm sellin my rustler... check out the link..

Brushless Rustler VXL CC Sidewinder 2.4GHz Futaba Radio
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

Hey guys! Man those two FLM Rusty's look awesome. I really like the blue but it'd suck to scratch all that anodizing off.

Haven't posted here for a bit, been busy. I got promoted to...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

Not as big of difference as between Nimh and Lipo..

To quote Warhead... "... I went Li-Po, and am amazed."

... also, yes, venom batteries are crap...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

HEY!!! Haven't posted here for a while. I got a fulltime job running a couple waterjets at a local aerospace manufacturer. I have access to LOTS of aerospace grade titanium sheet metal and am...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

HEY!!! I finally got my A123 packs rebuilt and have been testing it out. I did a three cell 10v triangle brick that fits nicely down into the front of the battery tray. Built three packs total,...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

Ok, this may be a stupid question, but I haven't figured it out yet, so maybe someone can shed some light on it.

What is the difference between a Rustler and a Rustler Roller??
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

I doubt that... you can tighten into the plastic pretty hard before they strip. Either they were already stripped, they got stripped in a wreck, or you over did it... the plastic they use is...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

I didn't get my tires off the ground until I went to Lithium batteries. NiMh just can't push the high amperage that the motor and esc can use (~60A), Lithium can!
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

What do you mean "what tires"? Didn't the pic show up in my last post? I can see it... it's also linked to the Tower Hobbies page for those tires.

Here a link to Tower Hobbies list of 1/10...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

http://www2.gpmd.com/image/i/imxc7401.jpg

Man... I dare say these tires might be better than the mashers!

Tower Hobbies has CRAPLOADS of tires and rims to choose from!
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

Can you change the LVC voltage setting?? You're probably hitting the limit when you accelerate. High amp pull will cause a voltage drop, you could probably turn the voltage setting down by a few...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

On my mashers they are interchangeable, yes. I've actually wanted to put the talons on backwards just for the hell of it. Probably look funny and handle weird..??
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

I bought my set lightly used on ebay for about $30, not sure what the brand is on the rims. I like them though cause they're the deep dish kind that actually widen your wheelbase.

Look at the...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

Bigger tires do the same thing as adding a few teeth to your pinion. It changes your effective gear ratio, so if you want the same gearing as with the smaller stock sized tires then you need to gear...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

Talons aren't much better, they're more of a street tire. Mashers do great in grass, sand or dirt. I have both...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

On the ground... your tires will change their angle from unsprung to neutrally sprung to fully loaded. You want to set your tires in the middle, where the weight of the car is just slightly...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

I also had this problem, and my dremel was also my answer. I put a small rounded metal grinding tip on it and just ground right down on top of the set screw till it was gone. Pain in the butt, but...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

If you're stripping gears, you probably don't have your mesh set right or maybe your main bearing to the spur is worn out. If the gears are properly meshed, you'd be more likely to snap an axle yoke...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

@Joe

The black chassis tells me that your rustler is old. They haven't made the black chassis for a few years I believe. That doesn't mean it's bad as long as it's been taken care of. Of...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

That's why I want all my electronics to be 100% waterproof. Washing the truck would be so much easier! Well... I guess my brushed rustler with the new blue electronics is waterproof, but the...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

Look for a used VXL. You'll probably want to upgrade to brushless after a short time. If you find one used either here or on eBay, you'll save a lot of time and money from upgrades.

Trust...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

Tower Hobbies, ebay or any other hobby supply place.

You can get them in silver, red or blue. I got the blue integy one's and returned them cause the ball joints were too tight.
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

Hell ya! Nice stonecolded! I love the mashers too, they look so good on it. Too bad they're not 4wd, huh?

I blew one of my A123 cells in my 10v pack, so I tore it down and I'm going to make...
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

Nice warhead, I like the blue and black carbon... looks sick! You could of used thumbnails though... especially for pics that big.
Replies: 11,114
Views: 756,623
Posted By simplecj

RE: Official Rustler Thread

Two questions... Where did you get that roll cage and how much to you have into that thing total? $1500??
Showing results 1 to 25 of 289
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.