RCU Forums - Search Results

Search: Posts Made By: Scott Schneider

Showing results 1 to 4 of 4
Search took 0.03 seconds.

Forum: Speed - RC Gas Boats

06-11-2011, 10:14 PM

Replies: 9

Looking for 8mm - 1/4" stepped prop shafts ( RCMK or MTC )

Views: 1,261

Posted By Scott Schneider

RE: Looking for 8mm - 1/4

Ah, the threaded on drive dog shafts :D .... yea thats the basic set-up. Tho looking for shafts only to solder sq drive cable into.
Looks like some of my European buddies are willing to set me up...

Forum: Speed - RC Gas Boats

06-11-2011, 07:36 AM

Replies: 9

Looking for 8mm - 1/4" stepped prop shafts ( RCMK or MTC )

Views: 1,261

Posted By Scott Schneider

RE: Looking for 8mm - 1/4

We need the larger diameter threw the bearing areas, running 75/85 mm props 1/4" bearings are getting beat to death, thus WHY wanting the bigger 8mm stuff ;)

Forum: Speed - RC Gas Boats

06-10-2011, 09:23 PM

Replies: 9

Looking for 8mm - 1/4" stepped prop shafts ( RCMK or MTC )

Views: 1,261

Posted By Scott Schneider

RE: Looking for 8mm - 1/4

No, that type is a reverse square drive 1/4 cable still requiring compression collet at engine.

Shaft I'm looking for are 1/4" at prop shaft, then step up to 8mm for the entire length of bearing...

Forum: Speed - RC Gas Boats

06-10-2011, 03:13 PM

Replies: 9

Looking for 8mm - 1/4" stepped prop shafts ( RCMK or MTC )

Views: 1,261

Posted By Scott Schneider

Looking for 8mm - 1/4" stepped prop shafts ( RCMK or MTC )

Like header states ... seeing if ANYONE these shores has any inventory of the H.D. 8mm prop shafts stepped to 1/4" having a 1/4" cable hole in the other end. ( need 1 .. would by 3 )

Worst...

Showing results 1 to 4 of 4