RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: stalledout
Showing results 1 to 13 of 13
Search took 0.07 seconds.
01-05-2012, 09:17 PM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

I ended up creating a flybar rod from a used bike spoke.

My heli always wants to go left. When I was repairing it, I noticed that one servo was set so the swashplate was not level, the left...
01-03-2012, 10:13 PM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

Looking up flybar mod, found it, .078 music wire, or 2mm carbon. 175mm long. Just broke mine tonight, I do have a spare frame I can take one off of, but will see if I have any .078 music wire...
04-01-2011, 04:19 PM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

FYI, Before swapping in one of the new motors, I tried one of new battery packs I got from Nitroplanes. Works great, no 'warm up' needed. Full power from the start. I did do a forming charge on...
03-28-2011, 10:37 AM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

Boy, this is embarrassing, I figured out the reason I was having trouble with that Rx, was because the crystal was loose!! Need to pay more attention.

Thanks for the tips on what to look for...
03-24-2011, 08:32 PM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

Thanks for the response. I did find the original NiMH batteries at Nitroplanes, I guess I will see how long they have been setting around when I get them. I also got two replacement main motors...
03-20-2011, 08:08 PM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

Thanks, I will look into ushobbysupply. Do you know what motor by chance? Or is it clear?

Why not lipo? - I live in a multi unit building with very young, very old, and very disabled...
03-20-2011, 01:09 PM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

Hello,

I am running my Falcon 40 V1 with the stock battery and a replacement main motor (I forget where I got the main motor from). Anyway, I started flying it again after not flying for quite...
05-22-2008, 01:15 PM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

Great Life,

The specs on my Falcon were in the post I referred to in my latest post. THe original post is copied at the bottom.

dknovick,

I kinda of thought that is what you guys were...
05-22-2008, 12:40 AM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

Hello,

I posted on page 235 post #5873 about having run out of right trim on the left control stick, and still having to put in a little right on the the left stick. Thanks for the suggestions...
05-19-2008, 06:42 PM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

Hello,

I have had my Falcon 40 for about two months and just had to replace the main motor. Got the one that USHobbySupply sells for the Walkera (I think). Anyway, right after I replaced it,...
04-30-2008, 01:28 PM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

Thanks Disney1 and UTM.

I did not know about the motor from Michael, I ordered one and hope it is here by the end of the week. His service is always fast.

Another question, how much...
04-29-2008, 03:07 PM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

Hello,

I have been flying a Falcon 40 for a few months and I think the main motor is about to gone bad. Last night, on a newly charged battery pack, the main rotor would only turn a a low rpm...
03-07-2008, 12:38 AM
Replies: 9,618
Views: 906,880
Posted By stalledout

RE: Falcon 40 (Exceed heli) Forum

Hello,

I have broken the frame on my Falcon 40. It broke back by the left servo and ahead of the the attachment point for the tail boom. My questions is, I have a new frame, can I reuse the...
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.