RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: lfinney
Showing results 1 to 7 of 7
Search took 0.02 seconds.
Forum: Extreme Speed Prop Planes
04-05-2014, 06:15 AM
Replies: 513
Views: 52,685
Posted By lfinney

mb 40 engines use the ball on crank scheme as...

mb 40 engines use the ball on crank scheme as well..IIRC
Forum: Extreme Speed Prop Planes
03-08-2014, 05:01 PM
Replies: 513
Views: 52,685
Posted By lfinney

I charge my Life batteries at 5C, and i test...

I charge my Life batteries at 5C, and i test cycle all of them when I buy them..i typically cycle them five times..never lost one yet..they are very stable balance wise as well... Nimh cel s arent...
Forum: Extreme Speed Prop Planes
03-08-2014, 07:42 AM
Replies: 513
Views: 52,685
Posted By lfinney

one restriction that i know of is the tail rotor...

one restriction that i know of is the tail rotor servos on heli's, but the new servos are built for it now
Forum: Extreme Speed Prop Planes
03-08-2014, 07:41 AM
Replies: 513
Views: 52,685
Posted By lfinney

life battery packs have the same peak voltage as...

life battery packs have the same peak voltage as Nimh when check directly after removal from chargers......I have used them on futaba and spektrum , JR and airtronics directly for five years now ,...
Forum: Extreme Speed Prop Planes
03-07-2014, 07:52 PM
Replies: 513
Views: 52,685
Posted By lfinney

700 mah two cell life battery..no bec needed just...

700 mah two cell life battery..no bec needed just plug it in and run it..under 4 dollars at hobby king
Forum: Extreme Speed Prop Planes
03-06-2014, 09:26 AM
Replies: 513
Views: 52,685
Posted By lfinney

the ucktam motors are rossi .15 clones, and they...

the ucktam motors are rossi .15 clones, and they often bought rossi sleeve and piston sets along with rods to use in their Russian clones..that being said there is plenty of rossi sleeve&pistons for...
Forum: Extreme Speed Prop Planes
02-27-2014, 10:18 PM
Replies: 513
Views: 52,685
Posted By lfinney

I sand with 600 grit wet or dry paper then vacuum...

I sand with 600 grit wet or dry paper then vacuum clean then use thinned balsarite...and sand again with 600 grit wet or dry and clean again...the monokote doesn't move or lift after that ever unless...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.