RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
Search: Posts Made By: douglasa
Showing results 1 to 8 of 8
Search took 0.05 seconds.
Forum: RC Warbirds and Warplanes
12-04-2009, 08:46 AM
Replies: 5,152
Views: 1,357,661
Posted By douglasa

RE: MOKI RADIAL Care and Maintenence

Scott,
Some actual figures for you: Moki 150 (12 hours run time 50:1 fuel mix)
Menz 3-Blade 24x16 at 5050rpm
Engel 3-Blade Carbon 24x16 at 5150rpm

On the 250 the Engel 2-Blade Carbon...
Forum: RC Warbirds and Warplanes
08-07-2009, 06:40 AM
Replies: 5,152
Views: 1,357,661
Posted By douglasa

RE: MOKI RADIAL Care and Maintenence

Hi Jim,
All you need to extend the exhausts are two lengths of Krumscheid tube, two Teflon couplers, and four spring clamps then dremel off the steel tube just proud of the cowl. I am not certain...
Forum: RC Warbirds and Warplanes
08-06-2009, 06:32 AM
Replies: 5,152
Views: 1,357,661
Posted By douglasa

RE: MOKI RADIAL Care and Maintenence

Hi Alex,
What pump at the bottom? Not sure what you mean unless you have the engine fitted upside down.
Rgds,
Doug
Forum: RC Warbirds and Warplanes
08-06-2009, 06:21 AM
Replies: 5,152
Views: 1,357,661
Posted By douglasa

RE: MOKI RADIAL Care and Maintenence

Hi Peter,
50:1 from the first tank full on my 150, to date it has just under 11 flying hours on it and runs like a Swiss watch. My friend Stuart has well over 200 hours on a 250 using the same fuel...
Forum: RC Warbirds and Warplanes
07-28-2009, 04:21 AM
Replies: 5,152
Views: 1,357,661
Posted By douglasa

RE: MOKI RADIAL Care and Maintenence

Hi Alex,
I’ve found that this starting procedure works well. On a tail dragger get your helper to hold the fuselage level or very slightly nose down. Set throttle to ¼, close choke, turn...
Forum: RC Warbirds and Warplanes
07-27-2009, 09:18 AM
Replies: 5,152
Views: 1,357,661
Posted By douglasa

RE: MOKI RADIAL Care and Maintenence

Hi Todd,
Looking at your photos there doesn’t seem to be much in the way of cooling outlet to let the hot air escape, do you have the cowl gills open? When flying does the engine run ok for three...
Forum: RC Warbirds and Warplanes
07-24-2009, 03:54 AM
Replies: 5,152
Views: 1,357,661
Posted By douglasa

RE: MOKI RADIAL Care and Maintenence

Hi Greg,
I have to be honest, we have not tried a 3 Blade on a 250. A friend with a 215 in a lightweight scratch built FW190 uses a 30x12 Menz and this goes well. As the 250 has a fair bit more...
Forum: RC Warbirds and Warplanes
07-23-2009, 04:14 AM
Replies: 5,152
Views: 1,357,661
Posted By douglasa

RE: MOKI RADIAL Care and Maintenence

Hi fellow radial users greetings from across the pond,
There is lots of good info going in here but also some misinformation. I will attempt to clarify some of the issues for you. Stuart Mackay the...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.