RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: 3D Joy
Showing results 1 to 7 of 7
Search took 0.10 seconds.
Forum: Giant Scale Aircraft - 3D & Aerobatic
05-06-2005, 07:58 AM
Replies: 150
Views: 30,893
Posted By 3D Joy

RE: 1/4 SCALE CAP 232 FORUM

Remember that the low speed needle has an effect to high speed and not the other way around. I suspect your low speed is too rich and high speed too lean. I may be wrong but your engine SHOULD...
Forum: Giant Scale Aircraft - 3D & Aerobatic
05-06-2005, 07:15 AM
Replies: 150
Views: 30,893
Posted By 3D Joy

RE: 1/4 SCALE CAP 232 FORUM

Sounds like your ZDZ 40 is too lean. It should pull your 14 lbs plane without too much troubble. I have flown one on a 13 lbs plane and it pulled HARD. I asked the guy to put some expo on the...
Forum: Giant Scale Aircraft - 3D & Aerobatic
05-05-2005, 04:02 PM
Replies: 150
Views: 30,893
Posted By 3D Joy

RE: 1/4 SCALE CAP 232 FORUM

Put your batteries in a bag under the engine in front of the firewall. You can also get cushioned boxes to keep your batteries from fuel, etc...
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-05-2005, 02:05 PM
Replies: 150
Views: 30,893
Posted By 3D Joy

RE: 1/4 SCALE CAP 232 FORUM

The H9 cap is tail heavy by nature so you may not be forced to put all servos in the tail. The G26 is not THAT heavy also. If it was my plane, I would put 2 elevator servos in the tail and 1 rudder...
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-29-2005, 09:58 AM
Replies: 150
Views: 30,893
Posted By 3D Joy

RE: 1/4 SCALE CAP 232 FORUM

Yes it is a bit tall. Depends on the angle you see the aircraft as in fact it is not THAT bad. Another factor may be that it is at the same time a bit narrow...

The engine is a YS140DZ. On...
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-29-2005, 08:23 AM
Replies: 150
Views: 30,893
Posted By 3D Joy

RE: 1/4 SCALE CAP 232 FORUM

I have the prototype wooden version of Genesis Caps and it flies GREAT. The Genesis version was modified from the version I have. It has bigger control surfaces, and some other minor changes. I...
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-24-2005, 07:50 AM
Replies: 150
Views: 30,893
Posted By 3D Joy

RE: 1/4 SCALE CAP 232 FORUM

Do not get over 11 lbs with a good gasser and you SHOULD be OK. I personaly don't think it is the best route though. I have a 11 lbs 1/4 scale cap 232 with a YS 140 DZ and it flies great with good...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.