RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: gunradd
Showing results 1 to 22 of 22
Search took 0.04 seconds.
Forum: RC Jets
03-23-2020, 06:09 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

Randy check and make sure your end points are...

Randy check and make sure your end points are correct with enough throw. When the gear is up it takes the brakes and steering out. Even though you have gear switch down it could be on the verge of...
Forum: RC Jets
04-28-2019, 06:44 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

Hate to say it but you need to cut all tat safety...

Hate to say it but you need to cut all tat safety wire off and redo it. Needs a double wrap or it can pinch and leak. I would not trust it like the others said.
Forum: RC Jets
02-08-2019, 06:56 PM
Replies: 1,631
Views: 334,584
Posted By gunradd

dont do a y. The controller shuts off at a...

dont do a y. The controller shuts off at a certain amperage. A y will double the amps and cause it to not function right.

have swapped the gear inputs to make sure the problem is not the retract...
Forum: RC Jets
01-06-2019, 06:06 PM
Replies: 1,631
Views: 334,584
Posted By gunradd

I parallel charge my receiver packs in all my...

I parallel charge my receiver packs in all my jets with out issues. All are kingtech LIFE batts.

I use 2 ISTD charges. One for both receivers and the other for the ECU.
Forum: RC Jets
01-01-2019, 04:54 PM
Replies: 1,631
Views: 334,584
Posted By gunradd

Please redo the safety wire also... it needs to...

Please redo the safety wire also... it needs to have a double wrap before the pig tail.

Granted I am an aircraft mechanic so very picky about safety wire but what you got is wrong and could pinch...
Forum: RC Jets
12-04-2018, 02:24 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

The stock JP controller does have a regulator...

The stock JP controller does have a regulator that’s why it’s rated for 2cell Lipo. This is also why the cable connecting the JP to your receiver should have the power wire cut and only a signal wire...
Forum: RC Jets
12-03-2018, 04:07 PM
Replies: 1,631
Views: 334,584
Posted By gunradd

DO NOT run the Lipo through the LG15 because it...

DO NOT run the Lipo through the LG15 because it does not have a voltage regulator and you will burn up the gear motors. Just run it all off the receiver LIFE batts
Forum: RC Jets
11-29-2018, 04:40 PM
Replies: 1,631
Views: 334,584
Posted By gunradd

Using the xicoy lg15 make sure you turn the cut...

Using the xicoy lg15 make sure you turn the cut off amps to the lowest setting. It comes at 1 amp I think but .5 is all that’s needed.
Forum: RC Jets
11-26-2018, 11:03 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

Well me being an aircraft mechanic and safety...

Well me being an aircraft mechanic and safety wiring all day long its second nature for me... But when I work on other peoples planes I come close to puking after seeing their safety wire jobs lol. ...
Forum: RC Jets
11-07-2018, 06:09 PM
Replies: 1,631
Views: 334,584
Posted By gunradd

That’s all easy stuff to fix. For the wing...

That’s all easy stuff to fix.

For the wing I would fill the hole with hysol. You can use regular automotive filler for it all after. If you want good stuff look up icing filler. If the glass is...
Forum: RC Jets
10-15-2018, 09:42 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

Just velcroe them to the side of the fuselage....

Just velcroe them to the side of the fuselage. Make sure you put some CA on the side that is on the fuse just to make sure it sticks good.
Forum: RC Jets
09-18-2018, 06:55 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

Squish it on. If it still is loose I prefer a zip...

Squish it on. If it still is loose I prefer a zip tie where the oring should sit.
Forum: RC Jets
09-17-2018, 03:13 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

T3chdad congrats on your maiden. Very happy you...

T3chdad congrats on your maiden. Very happy you had success on your first turbine. This is very important and its what gets more jet fliers going.
Forum: RC Jets
08-31-2018, 08:30 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

The F16 is doing great! Plan on getting her back...

The F16 is doing great! Plan on getting her back in the air this next weekend and doing some video I hope for the website.
Forum: RC Jets
08-31-2018, 08:29 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

Look on Ebay or amazon you can get the gun for...

Look on Ebay or amazon you can get the gun for about $20.00

You will need it flying jets so just grab it now.
Forum: RC Jets
08-30-2018, 07:49 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

make sure you have the max cut off amps set to...

make sure you have the max cut off amps set to lowest setting. .5 amps. The controller won’t enable the steering until gear is fully down with amps reached for cutoff. Also I think in the controller...
Forum: RC Jets
08-27-2018, 07:23 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

I have had bad luck with hitech servos. Love the...

I have had bad luck with hitech servos. Love the savox servos though.
Forum: RC Jets
08-26-2018, 04:23 PM
Replies: 1,631
Views: 334,584
Posted By gunradd

I have built a bunch of T1 airframes. The...

I have built a bunch of T1 airframes. The shipping time all depends on customs... sometimes it goes right through and others it sits for weeks. You never know.

T1 also has issues with their local...
Forum: RC Jets
08-23-2018, 03:52 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

Dirk works a real job during the day and then he...

Dirk works a real job during the day and then he runs all the servicing of engines for Kingtech USA along with pacific RCjets. Hes a very busy guy. So give him some time. Just talked to him last...
Forum: RC Jets
07-27-2018, 12:00 PM
Replies: 1,631
Views: 334,584
Posted By gunradd

Tipp22 great info thank you! I’m installing the...

Tipp22 great info thank you! I’m installing the xicoy controller in the new T1 F16. I used the controller on the B2 I built and loved it. So sounds like it works great with a LIFE battery. I hate...
Forum: RC Jets
04-20-2018, 06:07 PM
Replies: 1,631
Views: 334,584
Posted By gunradd

Post pics. I bet it's an easy repair

Post pics. I bet it's an easy repair
Forum: RC Jets
10-18-2017, 03:23 AM
Replies: 1,631
Views: 334,584
Posted By gunradd

Lior even 200mm might be nose heavy still. I was...

Lior even 200mm might be nose heavy still. I was moving it back every flight and simply ran out of stuff to move back easily while at the event. 200 should be a nice starting spot though but I am...
Showing results 1 to 22 of 22


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.