RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: asupervee72
Showing results 1 to 25 of 63
Search took 0.08 seconds.
08-13-2010, 12:55 AM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

fresh paint, nothing special and it didn't turn out really good or anything, but it looks way better then it did before, added some fiberglass to the sides to try and get rid of that seam cracking,
06-16-2010, 04:16 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

more batts from hobby king just showed up, also got the turnigy infrared temp taker, going to get my bearings from a shop down the hill, hope i have time to run it before the sun goes down
now i...
06-16-2010, 01:41 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

the boca bearings on ose look like the right size, i measured in SAE so hopefully my conversions were on, i got 11 mm for the OD 5mm for ID and 5 mm for width, i'm going to see if the lhs has any...
06-15-2010, 11:21 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

i called pegaus, a large distributor some what close to me, the guy there told me they could order them,
sushii2me, i have the turnigy 36-56 2300 kv motor but i blew my stock esc with it, i had a...
06-15-2010, 01:17 AM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

naw i want to replace the acutal bearings inside the can.
06-14-2010, 08:50 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

any body know where to get replacement bearings for the sv motor?, what size do i need?
05-25-2010, 09:08 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

2300 kv in the sv is insane, was fun running on 3s with a x437 and when i hooked up 4s it was insane, she is deffinetly faster then she was before, 20 dollar turnigy motor from hobby king is holding...
05-12-2010, 10:47 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

not exactly sure how to remove the strut bearing, i got a new one cause... well cause i figured it was old, just wanted some tips or advice before i take it on if anybody knows anything i should feel...
05-11-2010, 11:53 AM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

success is built on failure so i'm ok if it does happen, i will have to wait for my other cells and temp gun to come in before i can even try it and they are on back order so it's gonna be a month or...
05-11-2010, 11:22 AM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

i want to try 5s with the 2300 but you guys scared me into thinking it will explode or something? the weakest link is going to be the motor right? i'm going to have 4 mm bullets for all my...
05-10-2010, 08:37 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

got my cooling jacket, an x437, a bullet nut, bushing, and collet from kinetec racing today, now just waiting for hobby king, should i run the 2300kv on 4s with the x437 or should i put the sv motor...
05-04-2010, 07:17 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

so it's a bad idea? motor will fry or what?
43,500 some odd rpm too much? what about the sv motor with that esc on 5 s?
05-04-2010, 12:01 AM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

what do you think i can hit with 2300 kv on 5s running a x437?
05-03-2010, 09:15 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

i ordered the turnigy 3650 2300kv motor and turnigy marine 80 amp- hv esc (http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=8945) and wanted to run that on 5s with a x437, i ordered...
04-13-2010, 10:33 AM
04-11-2010, 07:51 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

i run the 220 on the stock motor and it does just fine
03-17-2010, 03:58 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

get rid of that left turn fin and kick the right one out a bit further then 90, that should get a little more speed
03-16-2010, 12:57 AM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

i had way more fun with my sv once i could worry less about flipping it
03-08-2010, 04:41 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

that is easy, www.hobbycity.com search the lipo for turnigy, what you want is 2s which means two cells ( lipo cells are 3.7 v compared to nihm 1.2v) find a battery that will supply at least 60 amps (...
03-05-2010, 10:21 AM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

made some passes in a river that happens to be running right now because of all the rain we were getting, it was pretty fun, more fun then running in a lake, take a look

...
03-03-2010, 04:45 AM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

300? look at the above post 2 2s cells - 60 , you can get a charger for 50 or less add a balancer for 20 plus you will need a lvc for lipo since the stock esc doesn't have one so there's 20. That...
03-02-2010, 05:22 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

i agree with this 100% i started with nihm on my sv and wish i wouldn't have because if i would have went with lipo in the first place it would have saved me some money, for me the sv would just...
03-01-2010, 08:54 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

wouldn't spend the money on nihm, why do you want to stay with nihm?
03-01-2010, 06:24 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

i use a lvc that is programmed to cut out at 3.3 v that i use for the sv but i really don't even let that kick in too often, to me the slow down is pretty noticeable when they are about done and like...
02-27-2010, 07:23 PM
Replies: 5,548
Views: 521,991
Posted By asupervee72

RE: Super Tune Your Super Vee 27

does anybody have their lawn mowed out there, do they have carpet to vacuum, what about a tv? The sv does make some noise but i really don't think you are outside your right to make a little bit of...
Showing results 1 to 25 of 63
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.