RCU Forums - Search Results

Search: Posts Made By: Bumpinyota

Showing results 1 to 7 of 7
Search took 0.05 seconds.

Forum: Speed - RC Gas Boats

01-08-2010, 09:33 AM

Replies: 17

Will any collet fit my shaft?

Views: 3,150

Posted By Bumpinyota

RE: Will any collet fit my shaft?

Got an issue now that it's finally arrived - the square ended ferrule sits a good 2" recessed into the stinger!

http://www.fotothing.com/photos/76a/76a311af987b0ed85c65fa15128121ad.jpg

...

Forum: Speed - RC Gas Boats

12-17-2009, 04:44 PM

Replies: 17

Will any collet fit my shaft?

Views: 3,150

Posted By Bumpinyota

RE: Will any collet fit my shaft?

THANK YOU!!!!!! That is precisely what I was looking for - a drive shaft that would hold the drive dog and have a square ended opening!! :D

thank you thank you thank you!!! :D

Forum: Speed - RC Gas Boats

12-17-2009, 10:35 AM

Replies: 17

Will any collet fit my shaft?

Views: 3,150

Posted By Bumpinyota

RE: Will any collet fit my shaft?

I wanted to avoid using that type of strut as it just doesnt look as clean as a stinger - with that in mind is it possible to use a square drive with a stinger strut that looks like this? ...

Forum: Speed - RC Gas Boats

12-17-2009, 10:32 AM

Replies: 17

Will any collet fit my shaft?

Views: 3,150

Posted By Bumpinyota

RE: Will any collet fit my shaft?

A square drive shaft in the stinger strut? Do you have a pic or a link to where I can get one?

Forum: Speed - RC Gas Boats

12-13-2009, 10:25 PM

Replies: 17

Will any collet fit my shaft?

Views: 3,150

Posted By Bumpinyota

RE: Will any collet fit my shaft?

Im sorry but Im completely lost... What is welded/soldered to the flex shaft in your pic?

Forum: Speed - RC Gas Boats

12-13-2009, 08:27 PM

Replies: 17

Will any collet fit my shaft?

Views: 3,150

Posted By Bumpinyota

RE: Will any collet fit my shaft?

here's where Im a bit lost though - If I use a square drive with the stock clutch I can not use a stinger right? Or do they make stub shafts that can be directly soldered onto the square endedshaft...

Forum: Speed - RC Gas Boats

12-13-2009, 06:18 PM

Replies: 17

Will any collet fit my shaft?

Views: 3,150

Posted By Bumpinyota

Will any collet fit my shaft?

I have a long shaft Ryobi that Im converting for use in an EasyVee from zip kits. The threads are 3/8-24 on the output shaft of the engine and stop 3/4" from the end of the shaft. Will any collet...

Showing results 1 to 7 of 7