RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Square Nozzle
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: Questions and Answers
02-22-2017, 02:52 PM
Replies: 12
Views: 820
Posted By Square Nozzle

Keith, the gain control on the transmitter should...

Keith, the gain control on the transmitter should only control the overall gain (all 3 axis will be affected simultaneously). As far as I am familiar with the system, individual gains are controlled...
Forum: Questions and Answers
02-13-2017, 05:26 PM
Replies: 12
Views: 820
Posted By Square Nozzle

Keith, expo over 10% makes the gyro hunt and...

Keith, expo over 10% makes the gyro hunt and you'll see the results in instability in the plane. It has something to do with the reduction in control movement around neutral. Your mention of 100%...
Forum: Questions and Answers
02-11-2017, 07:01 AM
Replies: 12
Views: 820
Posted By Square Nozzle

Keith, you probably picked this bit of info up...

Keith, you probably picked this bit of info up from the instruction manual. The dials on the gyro module also control the direction that the gyro moves the control surface. It's very important to...
Forum: Questions and Answers
02-10-2017, 10:15 AM
Replies: 12
Views: 820
Posted By Square Nozzle

Keith, I missed your question about Y connectors....

Keith, I missed your question about Y connectors. I would not Y the gyro. Give it it's own dedicated port in the receiver. As for initial settings, start low and progress to higher settings. When you...
Forum: Questions and Answers
02-09-2017, 06:52 PM
Replies: 12
Views: 820
Posted By Square Nozzle

Yes you can put the gyro on a dial if the...

Yes you can put the gyro on a dial if the receiver channel you are using can be controlled by a dial. That would be determined if you have Device Select or similar on your transmitter. That will...
Forum: Questions and Answers
02-09-2017, 10:53 AM
Replies: 12
Views: 820
Posted By Square Nozzle

Katman, my hookup and gain adjusting may be...

Katman, my hookup and gain adjusting may be different than your. I use a JR 12X transmitter. The first thing you want to do is insert the supplied harness into the appropriate channels in the...
Forum: Questions and Answers
02-08-2017, 04:35 PM
Replies: 12
Views: 820
Posted By Square Nozzle

Go ahead and chat. I have one in my Seawind. It's...

Go ahead and chat. I have one in my Seawind. It's been dunked in the lake a few times but still working fine.
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.