RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: stuffer
Showing results 1 to 13 of 13
Search took 0.11 seconds.
Forum: ARF or RTF
10-05-2005, 05:09 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

good deal. on to flying!
Forum: ARF or RTF
10-03-2005, 11:21 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

in short, the top ailerons will have more travel than the bottom depending on where you place the horns. ideally, like on the ultimates, the connecting rod should be on the trailing edge to get the...
Forum: ARF or RTF
10-03-2005, 10:34 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

I don't think it will help. believe me this has been discussed in detail in here somewhere. I tried most hints and finally decided that I would try it with the throws I got and found the plane to fly...
Forum: ARF or RTF
10-01-2005, 08:24 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

I have heard somebody using the original tank as the smoke tank and putting the gas tank at the CG.
Forum: ARF or RTF
10-01-2005, 07:06 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

your trying too hard! take it from me. don't worry about it. just pay attention to making sure the horn locations are the same on all ailerons. bottom left same as bottom right. top left same as top...
Forum: ARF or RTF
09-26-2005, 08:07 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

oak is good. coat them with thinned epoxy to fuel proof them and it adds strength. the reciever and battery are mounted per the instructions. I used "nyrod" for the throttle to eliminate...
Forum: ARF or RTF
09-24-2005, 07:57 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

you can use hardwood dowles. I used phenolic spacers. only because I had some available. hard wood will work just fine. Lowes has them so it's cheaper that way. just cut them all the same.
Forum: ARF or RTF
09-16-2005, 05:51 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

I wish I had pics but I made a small standoff bracket from 3/32 ply and mounted it to the firewall simular to the cowl mounts. I ran the left over throttle nyrod through that and to the choke. it...
Forum: ARF or RTF
09-16-2005, 05:21 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

I used the stock tank but changer the stopper to gas. I can fly 30 minutes on that tank. I use a wood 16x8 zinger for the looks. no vibration mount. I get about 8500 RPM after break in. flew it last...
Forum: ARF or RTF
09-12-2005, 04:44 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

ffdg, the throttle linkage wound up being a pretty much straight shot throught the firewall. I hooked up a manual choke and put it below the throttle. the centering of the engine was a little tricky...
Forum: ARF or RTF
07-14-2005, 01:46 PM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

just for show. it would be possible to make them 2 piece. a little cut here and there to make a joiner block for each wing. good luck!
Forum: ARF or RTF
07-11-2005, 05:10 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

I finnally flew mine yesterday. all I can say is "excellent"! flys better than I thought it would. I put in the G-26 for power and it flys so realistic. looks great in the air as well on the ground....
Forum: ARF or RTF
06-28-2005, 06:01 AM
Replies: 1,865
Views: 325,963
Posted By stuffer

RE: GP Super Stearman

I could sure use a clear pic of the throttle linkage setup for the G-26! I believe the standoffs are going to be approx. 3/4". did anybody use the linkage kit made for this? anything special I...
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.