RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: The Ghost
Showing results 1 to 12 of 12
Search took 0.02 seconds.
Forum: Gas Engines
09-13-2015, 04:53 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

Drive hub movement.

Hi All,
I don't know if this has been covered before with the length of the thread, but after replacing the prop to check a different size prop the engine would not idle as well as it used to....
Forum: Gas Engines
04-16-2015, 12:48 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

Hi, You won't be able to rotate the carby as...

Hi,
You won't be able to rotate the carby as the porting for the pump in the carby won't line up, you would need to make an adaptor plate with new porting for it to work.

Cheers
Forum: Gas Engines
04-14-2015, 05:38 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

Alan, Glad I could help. Cheers

Alan,
Glad I could help.
Cheers
Forum: Gas Engines
04-14-2015, 01:43 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

Alan, PM sent Cheers

Alan,
PM sent
Cheers
Forum: Gas Engines
04-08-2015, 01:24 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

You will need a 14mm thin walled deep socket for...

You will need a 14mm thin walled deep socket for the plug spanner.

Cheers
Forum: Gas Engines
04-08-2015, 01:22 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

I am using Supa Dri smoke oil in the video. ...

I am using Supa Dri smoke oil in the video.
Cheers
Forum: Gas Engines
04-07-2015, 11:57 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

Yes, just used the nipple already fitted to the...

Yes, just used the nipple already fitted to the muffler

Cheers
Forum: Gas Engines
04-07-2015, 09:46 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

Hi All, The rain stopped long enough to run the...

Hi All,
The rain stopped long enough to run the engine and test it on smoke. Running just over 6000rpm. Will have to set up the smoke pump now and test again.

Cheers...
Forum: Gas Engines
04-07-2015, 05:29 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

The Tap and Die arrived this morning, always get...

The Tap and Die arrived this morning, always get a set. Tapped out the adaptor and fitted, the engine is down around 100rpm at WOT, but is very quite, muffler and pipe from a ASP180FS. Will get the...
Forum: Gas Engines
04-07-2015, 12:34 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

AlphaWhisky, Have you looked at...

AlphaWhisky,
Have you looked at http://www.christiantraders.com.au/contents/en-us/d37_RCS_Right_Angle_Adapters.html, with one of there Flexible exhaust kits, you would need to make up an adaptor as...
Forum: Gas Engines
04-01-2015, 01:25 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

Alan, The original stand off's are 55mm long...

Alan,
The original stand off's are 55mm long and tapped both ends M5x0.8

Cheers
Forum: Gas Engines
03-26-2015, 01:04 PM
Replies: 1,678
Views: 461,741
Posted By The Ghost

Hi All, Mine arrived, runs very well after a...

Hi All,
Mine arrived, runs very well after a couple of adjustments. Any one tried running smoke on these engines.
I have set up mine with a temp and RPM sensors for telementry in the TX.
I have...
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.