Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: greenboot
Showing results 1 to 25 of 500
Search took 1.63 seconds.
Forum: Glow Engines
05-19-2009, 10:38 PM
Replies: 20
Views: 2,868
Posted By greenboot

RE: Saito 82a Ceramic Bearing Failure

Thanks for the ideas. I managed to get it out with a gear puller. I had to grind the hooks to fit in the groove.

Tom
Forum: Glow Engines
05-19-2009, 09:16 PM
Replies: 20
Views: 2,868
Posted By greenboot

RE: Saito 82a Ceramic Bearing Failure

So are you saying you can't just use a press on the front of the crankshaft? If I need those tools, I'll probably send it back to Horizon.

Tom
Forum: Glow Engines
05-19-2009, 09:01 PM
Replies: 20
Views: 2,868
Posted By greenboot

RE: Saito 82a Ceramic Bearing Failure

How do I remove the tapered collet and the drive flange on my Saito 150? They seem to be VERY tight. I'm trying to replace the bearings in it.

Tom
05-10-2007, 07:12 PM
Replies: 5
Views: 1,050
Posted By greenboot

I'm looking for 12 oz balsa plane

I have a Himax 2015-4100 brushless and it needs a plane. I'm done with foam and would like to try balsa. I can do a kit, scratch, or ARF, doesn't matter. Something around 32" and 12oz would be good....
05-14-2006, 09:11 PM
Replies: 21
Views: 1,480
Posted By greenboot

RE: Robart retracts lack of power

Any chance you could tell us how to do this???

Tom
02-21-2006, 04:49 PM
Replies: 1
Views: 436
Posted By greenboot

RE: 'Old' Cessna

The early Cessna 210 Centurion's had wing struts which disappeared in the late 60's. They also made a fixed gear version called the Stationair. Power was 315hp or 300hp in the turbocharged model. ...
Forum: Glow Engines
02-15-2006, 02:30 PM
Replies: 2
Views: 689
Posted By greenboot

Where to find YS110 or Saito 125

I'm looking for a big 4-stroke for my T-34 which is almost finished. Does anyone have the YS110 or Saito 125 in stock. I'd sure like to find a new one!

Thanks,
Tom
01-31-2006, 04:30 PM
Replies: 570
Views: 158,733
Posted By greenboot

RE: Top-Flite T-34

I have mine ready to install an engine but I'm still wondering what to use. Does the RCV fit with a stock muffler? I have the Robarts installed so I need a muffler that around them. I like the YS...
Forum: Gas Engines
02-09-2005, 11:27 AM
Replies: 32
Views: 2,557
Posted By greenboot

RE: Synthetic oil performance gain?

I've been wrong before, but I can't believe a 200 rpm power increases could be the result of the oil mixture. The need to adjust mixture because of oil seems strange also.

Tom
10-30-2004, 11:05 AM
Replies: 3
Views: 719
Posted By greenboot

RE: hirobo freya

I suppose you've already checked to see if you inadvertantly put a mix on the hold switch. My Freya comes down fine. My technique is to have some forward speed so the nose is already down. I always...
10-24-2004, 09:24 AM
Replies: 7
Views: 864
Posted By greenboot

RE: GP 1/3 330L servos & engine???

I use the big Hitec 5735 on rudder and just one 5645 per aileron. It depends somewhat on how much travel you want. As you add travel, the load increases and the mechanical advantage of the servo is...
10-24-2004, 09:03 AM
Replies: 8
Views: 820
Posted By greenboot

RE: Heli Motor

I thought it was already built. He has a picture of it right there in front of the little house. Maybe you can lift 3lb for $300, I'm not sure. How much you got?

Tom
10-23-2004, 09:39 PM
Replies: 13
Views: 1,801
Posted By greenboot

RE: Tail Fins why bother??

Lots of guys take the horizontal fin off. The vertical fin is needed to protect the tail blades. For backwards flying, you want as little tail area as possible.

Tom
10-23-2004, 09:36 PM
Replies: 8
Views: 820
Posted By greenboot

RE: Heli Motor

I'd be happy to help, do you need someone to fly it? How much weight are you planning to lift?

Tom
10-20-2004, 02:07 PM
Replies: 206
Views: 17,759
Posted By greenboot

RE: The unthinkable happened yesterday.....

airborne,
I can tell you know what your doing cause you came right to the best thread on the internet. :) Keep in mind, it's not always important to be correct, as long as your loud. I'm sure...
10-18-2004, 07:22 PM
Replies: 3
Views: 588
Posted By greenboot

RE: Remote Glow Clip Does anyone know why?

Are you using a glow starter attached to a power panel? Mine did that too. The small clip on igniters seem to not cause this.

Tom
10-18-2004, 07:20 PM
Replies: 8
Views: 2,500
Posted By greenboot

RE: OS 32 Engine Glow Plug

I've always used the cheapest plugs I could find, sometimes even used ones off the ground. Never had any trouble. I don't recommend this, but I sure don't understand all the excitement about...
10-18-2004, 07:17 PM
Replies: 5
Views: 738
Posted By greenboot

RE: Frustration beyond belief

Just how cold was it? Below 40 degrees, it is harder to get them to fire. Holding your finger over the exhaust helps prime it and is often useful.

Tom
Forum: Gas Engines
10-18-2004, 06:59 PM
Replies: 13
Views: 1,261
Posted By greenboot

RE: Replacing batteries on the ignition system

I'm always surprised to see people spend big bucks on carbon to save a few ounces, then install the biggest battery they can find to avoid charging. What's the world coming to? I have an 1100 mAh...
10-18-2004, 06:32 PM
Replies: 206
Views: 17,759
Posted By greenboot

RE: The unthinkable happened yesterday.....

Very good question. The aerodynamics of RC and full size are identical. How could they be differant? How could the air molecules know if the pilot is inside the plane or standing on the ground? If...
10-08-2004, 08:56 PM
Replies: 12
Views: 889
Posted By greenboot

RE: GP giant xtra 300L

I'm very happy the way my flies with a ZDZ 80. You'll save some money too. Changing the control surface hinge line would not be easy because of the way the kit is designed.

Tom
10-05-2004, 09:46 PM
Replies: 7
Views: 785
Posted By greenboot

RE: embedded flight computer for autonomous helicopter

The original space shuttle had less computer power than the original IBM PC. I would start with that and add more as necessary.

Tom
10-03-2004, 08:08 PM
Replies: 3
Views: 536
Posted By greenboot

RE: r /c INTERFERENCE ?

Your setup is not uncommon at all. Heavy duty extensions will minimize power loss in the long extensions. Do a range check with the engine running as a final test and go fly.

Tom
10-03-2004, 08:02 PM
Replies: 16
Views: 1,500
Posted By greenboot

RE: YW engines

Uh, did you mean YS engines?

Tom
09-27-2004, 09:58 PM
Replies: 12
Views: 1,060
Posted By greenboot

RE: New to ZDZ 80 Questions

I can answer some of your questions. I broke my engine in with the same 26x10 Bambula prop that I have been running ever since. It seems to work well. As far as the balls, I used them and they...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.