Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: wingster
Showing results 1 to 25 of 207
Search took 0.73 seconds.
02-28-2021, 01:50 PM
Replies: 152
Views: 57,108
Posted By wingster

To begin with I would mount the motor to the...

To begin with I would mount the motor to the wooden mount and temporarily install in the fuselage and check the clearance from backplate to the front of fuselage is adequate. You may need additional...
06-22-2020, 06:40 AM
Replies: 16
Views: 1,203
Posted By wingster

The two antennas are orientated at 90 degrees to...

The two antennas are orientated at 90 degrees to each other but are close together. Ideally they should be located farther apart.
04-01-2020, 07:12 PM
Replies: 4
Views: 848
Posted By wingster

The receiver battery should be connected while...

The receiver battery should be connected while setting the throttle.
01-24-2020, 08:02 PM
Replies: 17
Views: 5,835
Posted By wingster

How is the down line speed compared to the contra...

How is the down line speed compared to the contra setup?
08-17-2019, 03:05 PM
Replies: 7
Views: 4,045
Posted By wingster

It's a 42 pole motor, probably losing commutation...

It's a 42 pole motor, probably losing commutation synchronization as others have had with high pole count motors. You might try a jeti mezon esc which seem to do better with high pole count motors.
08-12-2019, 07:38 AM
Replies: 19
Views: 1,873
Posted By wingster

Looks like a Himax. Himax Brushless Motors...

Looks like a Himax.

Himax Brushless Motors 30-200 Watts (http://www.maxxprod.com/mpi/mpi-26.html)
05-29-2019, 04:44 AM
Replies: 23
Views: 8,475
Posted By wingster

Composite fuselage with film covered wings. I...

Composite fuselage with film covered wings. I found some other pictures which indicates BJ Craft construction.

SkyLeaf Leader “·‘Ì“h‘••Žå”ö—ƒƒtƒBƒ‹ƒ€“\‚è(ARF)+RSƒpƒbƒN•t+ŒÀ’èƒLƒƒƒŠƒ“ƒOBOX•t...
01-24-2019, 09:44 AM
Replies: 10
Views: 3,122
Posted By wingster

Google Translation Sounds like the Mezon...

Google Translation

Sounds like the Mezon controllers are overrated.

eason:
1. Mezon controllers are constructed differently than e.g. Master SPIN controller. Both
MEZON's only a few power...
07-21-2018, 02:49 PM
Replies: 377
Views: 50,263
Posted By wingster

I just received the Futaba version(MC9100A) from...

I just received the Futaba version(MC9100A) from Perth RC in Austraila. Shipping was about $25 and the price is reduced 10% because of the VAT tax. The price is in Aussie dollars so multiply by...
04-05-2018, 01:20 PM
Replies: 33
Views: 9,793
Posted By wingster

"I have noticed some cables (not Brodak) for...

"I have noticed some cables (not Brodak) for pull-pull are coated - what advantage might that be for our purpuse?"

You can wrap the ends a couple of times and use a match to melt the coating. ...
07-01-2017, 06:14 AM
Replies: 14
Views: 4,951
Posted By wingster

swk550 Nice info. The geared inrunners seem...

swk550

Nice info. The geared inrunners seem to have more torque with better verticals and less throttle management.
06-02-2017, 04:06 PM
Replies: 14
Views: 4,951
Posted By wingster

FinnSpeed, flyingtexan Thanks for your...

FinnSpeed, flyingtexan

Thanks for your input.

On my last flight on the Neu motor my prop and spinner flew off. This happened to me once before when the motor locked up. Before the flight the...
05-24-2017, 10:20 AM
Replies: 14
Views: 4,951
Posted By wingster

Any updates on performance and durability? ...

Any updates on performance and durability?

I'm looking to replace a Neu F3a geared motor which has once again failed. I was running a Falcon 3 blade 19.5x13 prop in an Allure. I really liked the...
04-14-2017, 12:26 PM
Replies: 9
Views: 1,946
Posted By wingster

As long as the cross wind is steady it will still...

As long as the cross wind is steady it will still fly a straight line if the rudder trim is correct.
04-13-2017, 05:23 PM
Replies: 9
Views: 1,946
Posted By wingster

Try flying directly away from you or towards you....

Try flying directly away from you or towards you. If the planes in a straight line the rudder trim is confirmed. A curved path indicates the rudder trim is not correct.
04-10-2017, 05:34 PM
Replies: 9
Views: 1,946
Posted By wingster

Before you make thrust adjustments you might want...

Before you make thrust adjustments you might want to make sure your rudder trim isn't off a couple of clicks.
11-02-2015, 01:46 PM
Replies: 732
Views: 162,626
Posted By wingster

Jason Thanks, 2 milliohms is excellent,...

Jason

Thanks, 2 milliohms is excellent, especially for a light pack.

John
11-02-2015, 06:34 AM
Replies: 732
Views: 162,626
Posted By wingster

Jason Do you have any IR data on the Dualsky...

Jason

Do you have any IR data on the Dualsky 4600 packs?
09-10-2014, 06:26 PM
Replies: 6
Views: 1,591
Posted By wingster

The Radio South springs are stiffer than the...

The Radio South springs are stiffer than the Futaba HD springs. On my 12FG I use the Futaba HD springs adjusted to maximum or near maximum.
09-02-2014, 02:35 PM
Replies: 14
Views: 2,051
Posted By wingster

Great!

Great!
09-02-2014, 12:17 PM
Replies: 14
Views: 2,051
Posted By wingster

Can you use the sbus programmable servos with a...

Can you use the sbus programmable servos with a non-sbus radio and still take advantage of the programming? It would be nice to set the endpoint via the programming rather than the transmitter...
08-08-2014, 02:03 PM
Replies: 80
Views: 24,364
Posted By wingster

Glad to hear it flies well. I was more...

Glad to hear it flies well. I was more concerned that the weight limits equipment choices and repairs. Also the weight from the factory is bound to vary.
08-08-2014, 09:31 AM
Replies: 80
Views: 24,364
Posted By wingster

It would be nice if the weight could be reduced...

It would be nice if the weight could be reduced without resorting too 4500mah batteries.
06-11-2014, 10:51 AM
Replies: 5
Views: 2,661
Posted By wingster

You could use 8 cells on the 6 cell motor but you...

You could use 8 cells on the 6 cell motor but you would have to decrease the prop size so as to limit the amp draw.
04-03-2014, 05:42 AM
Replies: 14
Views: 3,743
Posted By wingster

I'm running the Zippy Compact 5000 25C on the...

I'm running the Zippy Compact 5000 25C on the Neu. They work fine, but because the internal resistance(high 3's) is higher than my other packs, they run a little warmer.
Showing results 1 to 25 of 207
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.