Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: bluflu171
Showing results 1 to 10 of 10
Search took 0.57 seconds.
08-30-2009, 08:18 PM
Replies: 9
Views: 3,874
Posted By bluflu171

RE: Rebuilding a Stinson Voyager HELP!

I have a Realistic Models Stinson voyager 108-3 kit that has been stored inside my home and in excellent shape. all the parts are bagged, fiberglass cowl, and machined landing gear. .All the wood is...
Forum: MVVS Support
07-14-2009, 06:31 PM
Replies: 0
Views: 695
Posted By bluflu171

How to rotate plug boot on Evolution 40 GX

How do I rotate the plug boot 180 degrees on the current ignition wire.
Forum: Gas Engines
07-14-2009, 06:19 PM
Replies: 0
Views: 277
Posted By bluflu171

How to rotate plug boot on Evolution 40 GX

How do I rotate the plug boot on the current spark plug cable. I need to rotate the boot 180 degrees for a better fit with less strain.
Forum: Gas Engines
12-13-2006, 08:37 PM
Replies: 1
Views: 826
Posted By bluflu171

evolution 45 gx2

currentlymounting the Evolution 45 gx2 in a QQ yak-85". using standoffs, the carb just clears the firewall by 1/4 inch. will this be enough breathing room, or should I cut a hole in the firewall ?
11-07-2006, 06:36 PM
Replies: 11
Views: 1,000
Posted By bluflu171

RE: QQ-86'' Yak Estimated Arrival Date

Did you put a evo 45 in you 85" and if so how did it balance out and fly ?
10-24-2006, 03:22 PM
Replies: 1,488
Views: 152,775
Posted By bluflu171

RE: QQ 85" Yak

Just getting ready to install Evo 45. Any chance you got any photos of install. Thanks in advance
10-24-2006, 03:03 PM
10-24-2006, 02:19 PM
Replies: 3
Views: 275
Posted By bluflu171

Template for Evolution 45 for 85"

Does anyone have a template for the Evolutin 45 for the 85"
10-24-2006, 02:12 PM
Replies: 0
Views: 45
Posted By bluflu171

Evolution 45 template for 85"

Does anyone have a template for the Evolution 45 for the 85"
03-09-2006, 02:47 PM
Replies: 1,488
Views: 152,775
Posted By bluflu171

RE: QQ 85" Yak

Does the landing gear "sweep" face forward or to the rear. If your lay the gear on a flat surface. one side sits flush and the other side is angled. Is the angled side forward or aft ?
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.