RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: rnemovr
Showing results 1 to 25 of 45
Search took 0.45 seconds.
Replies: 23
Views: 683
Posted By rnemovr

Would be nice. I know my luck 6-8 weeks.

Would be nice. I know my luck 6-8 weeks.
Replies: 23
Views: 683
Posted By rnemovr

Tried this and now it works, but only forward....

Tried this and now it works, but only forward. Some how I reset it and lost reverse.
Replies: 23
Views: 683
Posted By rnemovr

I took it to the local hobby shop and they...

I took it to the local hobby shop and they confirmed a bad ESC. Talked to the PO and he has the receipt and I am going to warranty it out.
06-27-2015, 12:13 AM
Replies: 6
Views: 2,786
Posted By rnemovr

Entire cars have been made ...

Entire cars have been made

https://www.youtube.com/watch?v=5mPUtSrMoLw
Replies: 324
Views: 99,395
Posted By rnemovr

Not bad

Not bad
Replies: 23
Views: 683
Posted By rnemovr

It's back to messing up

It's back to messing up
Replies: 324
Views: 99,395
Posted By rnemovr

So how much does this thing weigh so far?

So how much does this thing weigh so far?
Forum: RC Drifting
06-26-2015, 12:53 PM
Replies: 2
Views: 1,994
Posted By rnemovr

Converting a drifter?

I am looking to trade my crawler for a SCT/SCB, just something I can bash on. A guy offered to trade me a drifter that has tekin fxr, 4000 mah 3s traxxas rx/tx some spare tires, spare esc and new set...
Replies: 23
Views: 683
Posted By rnemovr

We wanted a nice poser shot considering it is the...

We wanted a nice poser shot considering it is the only water in about 2 hours. Then Jeeps happened.
Replies: 23
Views: 683
Posted By rnemovr

The fires I am not worried about. From everything...

The fires I am not worried about. From everything I have read they are usually operator error. I was thinking of 30-40C rating. I know it isn't cheap as I used to run nitro's. Then I was single and...
Replies: 23
Views: 683
Posted By rnemovr

Just went out and ran a full battery, battery...

Just went out and ran a full battery, battery didn't have hardly any heat.
Replies: 23
Views: 683
Posted By rnemovr

Any brand lipo to avoid? Also with the setup I...

Any brand lipo to avoid? Also with the setup I have I know I need a 2S or 3S but what C rating?
Replies: 23
Views: 683
Posted By rnemovr

I have Deans plugs. That $100 start up sure sucks...

I have Deans plugs. That $100 start up sure sucks though.
Replies: 23
Views: 683
Posted By rnemovr

So then where is best place to go?

So then where is best place to go?
Replies: 23
Views: 683
Posted By rnemovr

I doubt I'll run a Lipo. I'm just a basher who...

I doubt I'll run a Lipo. I'm just a basher who would rather spend money on my 1:1
Replies: 23
Views: 683
Posted By rnemovr

Reset the ESC per instructions on link below and...

Reset the ESC per instructions on link below and it seems to be working. Talked to previous owner and he ran Lipo so that may have been issue.
...
Replies: 23
Views: 683
Posted By rnemovr

I know it isn't the battery as I have two and...

I know it isn't the battery as I have two and both do the same. I will see what I can do about resetting. I got the truck used on a trade so no manual.
Replies: 23
Views: 683
Posted By rnemovr

Problems with brushless Blitz

Have a question about an HPI Blitz with the motor and ESC linked below. I am running 7.2v 3000MaH NiMH battery. It drove fine at first but now it is acting up. I will be driving and it will stop...
02-05-2013, 01:38 PM
Replies: 19
Views: 5,617
Posted By rnemovr

RE: low bucks 6x6 vacation build

Very sweet build. Nice fab work.
02-05-2013, 01:10 PM
Replies: 0
Views: 494
Posted By rnemovr

Losi MRC electrical issues.

My controller is a Team Associated XP3 (3ch), My receiver is a HPI RF-2 (4ch) (they both use the same crystal and have worked on my old nitro), the ESC is a Novak 410-HPc, the motor is a stock MRC,...
01-23-2013, 06:43 AM
Replies: 3
Views: 409
Posted By rnemovr

RE: Parts and stores near Savannah

On side note the buggy runs. Runs like crap but does run. I need help tuning.

Few pics of everything.

http://i128.photobucket.com/albums/p176/rnemovr/RC/0122131951.jpg

The XL after...
01-22-2013, 04:51 PM
Replies: 3
Views: 409
Posted By rnemovr

RE: Parts and stores near Savannah

The Savage is now just a frame, transmission and front end. I used parts from it to get the XL almost complete
01-22-2013, 03:56 PM
Replies: 3
Views: 409
Posted By rnemovr

Parts and stores near Savannah

The nearest RC store is over an hour away so buying local is not going to happen. Where is the best place online to get parts.

Part 1. I have an Associated MGT 4.6. I had to replaced the broken...
07-01-2007, 10:16 AM
Replies: 11
Views: 583
Posted By rnemovr

RE: i need directions

i needed the part that is 2 spots over from the top one you circled
06-29-2007, 02:13 PM
Replies: 11
Views: 583
Posted By rnemovr

RE: i need directions

ok i just started taking parts off and found the one i needed, and it wasnt the ones you circled, i would like to know what the rest of them are,
Showing results 1 to 25 of 45
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.