Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: tripower222
Showing results 1 to 25 of 307
Search took 0.27 seconds.
03-05-2011, 06:21 PM
Replies: 556
Views: 94,832
Posted By tripower222

RE: 30cc Edge 540 build

Since my only experiance with the planes you mentioned is with the Aeroworks 30cc Edge I can't make comparisons. I can say the the AW 30cc Edge kit is a pretty high quality kit compared to most I...
Forum: Gas Engines
03-03-2011, 05:31 PM
Replies: 4
Views: 858
Posted By tripower222

lock washers

I have stumbled across these new lock washers. They work unbelievably well in high vibration applications. The link I am adding is just the company I have used I think there is another brand called...
03-03-2011, 05:15 PM
Replies: 556
Views: 94,832
Posted By tripower222

RE: 30cc Edge 540 build

Not sure about the sesitive elevator. Im going to guess if you ballanced well you like it better with more expo. I always fly with full rate flight controls with lots of expo I run like 65%. As for...
Forum: Gas Engines
02-09-2011, 06:01 PM
Replies: 26
Views: 3,120
Posted By tripower222

RE: DLE 30 dieing at full throttle

mechanical speed setting??????? not familliar with that term/phrase
Forum: Gas Engines
02-09-2011, 04:13 PM
Replies: 26
Views: 3,120
Posted By tripower222

RE: DLE 30 dieing at full throttle

Ok, just ran a tank through it. It didn't die but i'm still not convinced yet I'll get another couple tanks through it then I will feel better. Couple things still I feel are not right still,
when...
Forum: Gas Engines
02-08-2011, 09:07 PM
Replies: 26
Views: 3,120
Posted By tripower222

RE: DLE 30 dieing at full throttle

I'll give it a whirl without the valve before I swap carbs, I'm sure its not sucking air as I would see the air in the line. There is not much else it could be but the fueling valve. Ive been a...
Forum: Gas Engines
02-08-2011, 08:45 PM
Replies: 26
Views: 3,120
Posted By tripower222

RE: DLE 30 dieing at full throttle

It does it in air and on ground, with or without cowl. Carb looked clean inside, blew out passages reassembled but have not tried it yet but i dont think it's going to be good as I didn't find...
Forum: Gas Engines
02-06-2011, 11:37 AM
Replies: 26
Views: 3,120
Posted By tripower222

RE: DLE 30 dieing at full throttle

Sounds like its time to open up the carb must be something in there. Im sure its not an air leak, to affect full throttle it would have to be a massive air leak and not run worth a crap at low...
Forum: Gas Engines
02-06-2011, 11:12 AM
Replies: 10
Views: 986
Posted By tripower222

how does an engine act when ign. batt dies

How does an engine act when the ignition battery dies? Do different ignitions act different? Is it a spit sputter and die, an instant off, a slow drop in power or what?
Forum: Gas Engines
02-06-2011, 11:06 AM
Replies: 26
Views: 3,120
Posted By tripower222

RE: DLE 30 dieing at full throttle

Hmm, battery, didn't think about that I am running a 4.8 battery for ignition, maybe the full throttle ignition current is pulling the battery down. Woulkd those be the symptoms of a dieing ignition...
Forum: Gas Engines
02-06-2011, 09:49 AM
Replies: 26
Views: 3,120
Posted By tripower222

DLE 30 dieing at full throttle

Having a little trouble with my new DLE 30. I have almost a gallon through it and has been giving me trouble since the first tank. Aside from what I think is a little excess vibration I can adjust...
Forum: Gas Engines
01-31-2011, 07:49 PM
Replies: 43
Views: 4,357
Posted By tripower222

RE: ignition module test results

w8ye I believe you mean well but a good many of your post seem like your just trying to make a post to increase your posting stats or somthing. You may want to look again it says a lipo battery...
Forum: Gas Engines
01-31-2011, 05:36 PM
Replies: 43
Views: 4,357
Posted By tripower222

RE: ignition module test results

even your link says the 6.6v LiFe battery is ok
Forum: Gas Engines
01-31-2011, 05:32 PM
Replies: 43
Views: 4,357
Posted By tripower222

RE: ignition module test results

http://dle-engines.com/dleg0031.html

this is from the botton of the page on dle engines website

Recommended Options:
FPWP4195 FlightPower® EON-X Lite 7.4V 2100mAh 25C LiPo Pack
...
Forum: Gas Engines
01-31-2011, 05:05 PM
Replies: 43
Views: 4,357
Posted By tripower222

RE: ignition module test results

I'm not saying this with experiance as I have not done it but The manual and Hobbico tech support says you can run the new ignitions with a LiFe battery without reducing the voltage.

I Also...
Forum: Gas Engines
01-31-2011, 06:18 AM
Replies: 5
Views: 791
Posted By tripower222

RPM drop in bank turn?

I’m running a DLE 30 and for some reason when I'm flying strait and level with no change in throttle input, when the plane makes a bank turn the rpm drops. Its more than just a little if I had to...
Forum: Gas Engines
01-30-2011, 08:27 PM
Replies: 4
Views: 940
Posted By tripower222

DLE 30 19x8 Xoar, beech or laminated?

Hoping Jody or TOM can chime in on this one.

Had a beech one, but broke it today on a dead stick landing, for the negligable price differance if the laminated is better I'll go that way this...
Forum: Gas Engines
01-30-2011, 03:26 PM
Replies: 7
Views: 3,137
Posted By tripower222

DLE 30 3D prop

Anyone used the 18x6w APC prop on the DLE30 and howd ya like it.
01-30-2011, 03:19 PM
Replies: 556
Views: 94,832
Posted By tripower222

RE: 30cc Edge 540 build

Makes sense, I actually tried both directions to cure the idle issue with no success. I'll play with it when I get a chance and let you know what I find. I'm sure I just have some adjustment issues.
01-30-2011, 01:07 PM
Replies: 556
Views: 94,832
Posted By tripower222

RE: 30cc Edge 540 build

Just got home from maidening the new Edge, in summery the plane flies great but I'm having some motor trouble, two of five flights where dead stick and engine speed was a little eratic on all flights...
Forum: Gas Engines
01-29-2011, 02:49 PM
Replies: 6
Views: 1,737
Posted By tripower222

RE: New DLE 30 idle issue

Good call Jody, the screw was tight but the plate was out of position. I loosened the screw and repositioned the plate so no light showed around the perimeter and that took care of it.
01-29-2011, 10:23 AM
Replies: 556
Views: 94,832
Posted By tripower222

RE: 30cc Edge 540 build

Muffler hitting cowl,

Even after grinding more off the muffler than I am comfortable with the muffler still rubs the cowl. If you want the muffler inside the cowl you may try this.
I remounted...
Forum: Gas Engines
01-27-2011, 09:07 PM
Replies: 6
Views: 1,737
Posted By tripower222

RE: New DLE 30 idle issue

sounds good i'll give it try thanks
Forum: Gas Engines
01-27-2011, 09:04 PM
Replies: 6
Views: 1,737
Posted By tripower222

RE: New DLE 30 idle issue

Are you serious???

For starters throttle cut doesn't work, the plane has too much idle thrust as it is, it could have a partial vacuum causing poor idle performance, and most of all it ain't...
Forum: Gas Engines
01-27-2011, 08:31 PM
Replies: 6
Views: 1,737
Posted By tripower222

New DLE 30 idle issue

Got a tank an a half through a new DLE 30 and it will not idle down past 1700. Idle screw is out to the point the throttle plate is what is stopping the throttle. How is the air getting in? Throttle...
Showing results 1 to 25 of 307
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.