Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: ve7dpg
Showing results 1 to 11 of 11
Search took 1.96 seconds.
Replies: 10
Views: 3,410
Posted By ve7dpg

okay thanks to all for the ideas, my radio is a...

okay thanks to all for the ideas, my radio is a hitec eclipse 7 and after looking at reversing the servo itself i should of done that before burying it in the wing,it would be a pain to pull it back...
12-14-2013, 10:47 PM
Replies: 0
Views: 339
Posted By ve7dpg

8ft unionville turbo beaver power question?

I have an 8ft unionville turbo beaver kit that will go on floats I was going to use an os 120se for power but ended up using that on my Rascal 110 I am looking for ideas for possible a gas engine...
Replies: 10
Views: 3,410
Posted By ve7dpg

servo reversing question?

Hi all my question is this I need to reverse a servo for flap operation on a Sig rascal 110 i have purchased an expert servo reversing y harness which seems to work, but I was thinking of...
Replies: 1
Views: 443
Posted By ve7dpg

world engines Rx question??

Hi:

Maybe someone has the answer to the following question I have a world engines rx from an expert radio system it is a 7ch narrow band fm wich uses the negative pulse.
model number is...
Replies: 4
Views: 672
Posted By ve7dpg

RE: rx and tx frequency changes?

;)

well i guess but I was talking about FM not to many repeaters use SSB upper or lower!


73 Warren
Replies: 4
Views: 672
Posted By ve7dpg

rx and tx frequency changes?

Okay I have a question since I have been a ham and we change crystals in a radio it is always necessary to net the crystal to the desired frequency, no two crystals will oscillate at exactly the same...
Replies: 1
Views: 417
Posted By ve7dpg

Hitec flash 5 (older one)

[:o]
HI I have a hitec flash 5 tx and whats happening is that when I went to set it up in a new airplane with a new flight pack I noticed that I had no left airilon (ch1) right was ok no left
i...
Forum: Glow Engines
03-31-2003, 07:47 AM
Replies: 2
Views: 617
Posted By ve7dpg

looking for a pitts style muffler to fit magnum pro .61 or .46

Hi I am looking too see if anyone knows if there is a pitts style muffler that will fit either
a magnum pro se .61 or a magnum pro se .46
both these engines are made in taiwan.

I would prefer...
Replies: 9
Views: 2,076
Posted By ve7dpg

World Engines Expert 7ch and parkflyers?

okay thanks, I would be willing to send you some cash!

thanks Warren here is my direct email

[email protected]
Replies: 9
Views: 2,076
Posted By ve7dpg

World Engines Expert 7ch and parkflyers?

sure sounds good not sure if a schematic will help me right now but maybe i could find some other sticks to install then the schematics would be helpful. I just rebuilt the tx and rx battery packs so...
Replies: 9
Views: 2,076
Posted By ve7dpg

7ch expert transmitter (blackand silver)

Hi I also have one of these just wondering if you
knew of one for parts? My plastic piece that centers the stick (right hand) is broken, I think these were a weak piece as the left one broke when...
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.