Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: elecfly
Showing results 1 to 25 of 128
Search took 0.56 seconds.
09-22-2008, 12:46 AM
Replies: 16
Views: 1,615
Posted By elecfly

RE: i give up

think he means raptor
09-20-2008, 12:59 AM
Replies: 1
Views: 919
Posted By elecfly

RE: First airbrushed body and thoughts for noobs

Is that a winch on the front? how about making slots either side(front and back) . Get some twine , not too thin so its visible.
Then take it in front slot over and out back and keep going round ,...
09-20-2008, 12:51 AM
Replies: 16
Views: 1,425
Posted By elecfly

RE: Rapter 30 v1

I really think its just setup.

Get it to a local flying field with heli pilots let them set it up for you
09-19-2008, 01:31 AM
Replies: 16
Views: 1,615
Posted By elecfly

RE: i give up

Is the gyro set to use a non digital servo? the servo is too slow for the gyro

get a flippen 9254 !!!
09-19-2008, 12:58 AM
Replies: 16
Views: 1,615
Posted By elecfly

RE: i give up

what tail servo asre you using?
09-18-2008, 02:43 PM
Replies: 16
Views: 1,425
Posted By elecfly

RE: Rapter 30 v1

the way you mention pitch curves doesnt really say anthing , you must get a pitch gauge and see what pitch the blades are at every throttle position.

this way at half stick if the blades...
09-18-2008, 02:40 PM
Replies: 16
Views: 1,425
Posted By elecfly

RE: Rapter 30 v1

go to www.raptortechnique.com .

They have lots of info onsetting up for how you want to fly.
09-18-2008, 10:49 AM
Replies: 16
Views: 1,425
Posted By elecfly

RE: Rapter 30 v1

Can you fly ?
09-18-2008, 09:55 AM
Replies: 16
Views: 1,425
Posted By elecfly

RE: Rapter 30 v1

up the pitch rather , the throttle curves you have now is VERY low.

Are you hovering on midstick?
09-18-2008, 04:57 AM
Replies: 4
Views: 893
Posted By elecfly

RE: Helicopter found

Very nice of the guy!
09-18-2008, 04:53 AM
Replies: 222
Views: 26,963
Posted By elecfly

RE: Raptor 90 3D Project

Waar vlieg julle nou Marcel?
09-18-2008, 03:38 AM
Replies: 8
Views: 977
Posted By elecfly

RE: raptor 30 comes down with no input

And the motor was still running?
05-20-2008, 03:26 AM
Replies: 9
Views: 1,380
Posted By elecfly

RE: raptor .30 rotor head shakes

The headspeed could be too high
05-18-2008, 10:00 AM
Replies: 222
Views: 26,963
Posted By elecfly

RE: Raptor 90 3D Project

Damn thats a bad way to almost lose a heli , what servo was it?
05-13-2008, 07:16 AM
Replies: 7
Views: 991
Posted By elecfly

RE: Sevo Advice for a Newbie!

I use DS589's . They arent that expesive , good performance and digital , and on the you cant go wrong with the 401/9254 combo.
If you want to upgrade to a 50 later and spend money now on the...
05-09-2008, 08:17 AM
Replies: 6
Views: 1,722
Posted By elecfly

RE: Raptor 30 Main Rotor Blades

go swop them for 550's
05-08-2008, 07:05 AM
Replies: 7
Views: 990
Posted By elecfly

RE: Pitch Servo

I dont think on a raptor30 you will notice any difference?!

BUT - $10 is not that much difference to get the better servo! so i say get the 6975
05-08-2008, 04:32 AM
Replies: 7
Views: 990
Posted By elecfly

RE: Pitch Servo

6965 is a great servo and also the 6975(This one has is stronger and better for pitch i would say). 6975 is stronger and 6965 is faster , same servo differnt gears.
05-02-2008, 10:19 AM
Replies: 16
Views: 1,752
Posted By elecfly

RE: Raptor 50 or 30

I have a 30 and am going to learn with it until I outfly it and then buy a 50.
You can almost fly twice as long on the same amount of fuel and flight time is most critical when learning to fly.
...
04-23-2008, 11:26 AM
Replies: 6
Views: 1,115
Posted By elecfly

RE: Raptor TT 50 pro motor problems

If theres an air link the header tank wont be full all the time , check that too.
04-23-2008, 08:03 AM
Replies: 6
Views: 1,115
Posted By elecfly

RE: Raptor TT 50 pro motor problems

Take the engine apart and clean it properly. Also the needle , make sure there is no debris inside .
If a motor stood for that long the nitro and methanol evaporates from where it lies inthe motor...
04-23-2008, 03:06 AM
Replies: 222
Views: 26,963
Posted By elecfly

RE: Raptor 90 3D Project

Canopy blades and tail.

The skids also but not so much as the rest, skids on top = heli upside down...
04-18-2008, 10:23 AM
Replies: 14
Views: 952
Posted By elecfly

RE: GYRO??

So on the switch that you set between HH and Normal mode , your gain is +75 / ?

Think it should be 80/30 ?
04-18-2008, 01:30 AM
Replies: 14
Views: 952
Posted By elecfly

RE: GYRO??

Is it in HH mode? red light on and not blinking?
Forum: Kit Building
04-01-2008, 07:03 AM
Replies: 240
Views: 24,550
Posted By elecfly

RE: Four Star 40 with Saito 56

Andrew ,

The blue and yellow is a nice colour choice, some people say blue cant be seen in the air , but with yellow makes a nice contrast in the colours.

See my Kobra with blue and yellow...
Showing results 1 to 25 of 128
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.