Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: cslota
Showing results 1 to 11 of 11
Search took 0.92 seconds.
10-05-2010, 12:55 PM
Replies: 8
Views: 864
Posted By cslota

RE: What is the best cycler to buy Triton or elite ?

I have the Triton Jr. and two of the Elites. Of the two, the Elite is better. You can use the Elite at the field or work shop. Plus it will charge two batteries at the same time. In fact, you can...
10-01-2010, 08:44 PM
Replies: 47
Views: 2,869
Posted By cslota

RE: What to use.... Propeller question??

I used a 70 four stroke! No balance with that engine!
09-18-2010, 11:15 AM
Replies: 4
Views: 923
Posted By cslota

How to balance an airplane with a pod mounted engine above the wing

I have a Ken Willard designed Wave Master that has the engine in a pod above the wing. I have tried to balance it both up right and inverted. The problem I have is that when balance is close to...
08-30-2008, 05:41 AM
Replies: 1
Views: 2,136
Posted By cslota

Piper J3 Club Landing Gear

Has anyone tried using the landing gear from Piper J3 Club? (http://www.piperj3gear.com) I am wondering if thier landing gear does what they say if does.

Thanks,

Calvin
08-30-2008, 05:25 AM
Replies: 30
Views: 6,875
Posted By cslota

RE: Fuel Tanks in the Wing ???

If you had both wing tanks feed into a small main tank located in the fuselage, then you could put the fuel clunk in the small main tank. This type of set up should keep the main tank full of fuel....
08-18-2008, 11:33 AM
Replies: 14
Views: 1,783
Posted By cslota

RE: Magnum .52 rfs engine noise

Wingnut,

Do you have an owners manual for your magnum 52 four stroke? If so I would like to get a copy of it. I bought a used engine and I didn't get an owners manual.

Thanks,

...
03-14-2008, 01:02 PM
Replies: 11
Views: 1,408
Posted By cslota

RE: will high power lines give you Radio freq. interferance

I agree with jburryabout fenches causing glitches, the safety fence at our field caused the wing of my airplane to rip off when I flew into it!

Cal
09-06-2007, 12:43 PM
Replies: 4
Views: 732
Posted By cslota

RE: wing-strut bolts

Screw on a clevis to the end of the strut then snap the clevis shut on the tabs that protrude from the fuse. Durbo also makes a quick disconnect set up that would screw onto the strut. It uses a...
05-12-2007, 05:12 AM
Replies: 6
Views: 1,951
Posted By cslota

RE: How to braise piano wire

Thanks for the link on how to bend and form wire using heat treating, I will save that. But what I am looking for is information on how to baze to seperate pieces of piano wire together. I want to...
05-11-2007, 09:42 PM
Replies: 6
Views: 1,951
Posted By cslota

How to braise piano wire

I am making a new landing gearing out of piano wire so I can put my airplane on floats. I would like to know how to braise to wire together.

Thanks,
04-14-2007, 08:40 PM
Replies: 1
Views: 405
Posted By cslota

Magnum Engines, what is the difference between XL and XLS

What is the difference between an XL and XLS with regards to a 52 four stroke engine?

Thanks
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.