RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Sharpeye22
Showing results 1 to 25 of 332
Search took 0.39 seconds.
Forum: Marketplace
06-12-2018, 02:13 PM
Replies: 2
Views: 264
Posted By Sharpeye22

Robart struts for a Great Planes Ryan STA

I'm looking for the Robart Struts for a GreatPlanes Ryan STA.
Well used or even damaged is fine as long as I can repair them.
If anyone has a set they would like to sell, let me know how much you...
Forum: Marketplace
06-11-2018, 05:04 PM
Replies: 0
Views: 265
Posted By Sharpeye22

Robert Struts for Great Planes Ryan STA

I'm looking for the Robart Struts. I put this by mistake in the for sell but It should be in the wanted section. I could not move it so I made a corrected add in the want add section.
Forum: Glow Engines
08-10-2017, 01:48 PM
Replies: 51,597
Views: 3,415,071
Posted By Sharpeye22

Problem solved

The Wasp nailed my problem. I checked the valves and sure enough they were all loose. Thing is the side that was running was almost as loose as the side that was not running. I reset them as per...
Forum: Glow Engines
08-10-2017, 12:52 PM
Replies: 51,597
Views: 3,415,071
Posted By Sharpeye22

Follow up on cylinder not firing

I have not had a chance yet but I will check and set the valves,
Both cylinders are very close in the amount of compression they each have.
It is a pain to pull the engine off the aircraft but if I...
Forum: Glow Engines
08-09-2017, 05:24 PM
Replies: 51,597
Views: 3,415,071
Posted By Sharpeye22

right cylinder does not fire on SAIEG57T

I am at my wits end. The right cylinder does not fire on my Saito FG57 twin. Things I have done.

Switched the right and left high tension leads. Right one still not firing
Replaced the ignition...
04-26-2017, 09:19 AM
Replies: 4
Views: 925
Posted By Sharpeye22

So Andy, I think I got it. I could put an AR636...

So Andy, I think I got it. I could put an AR636 in the upper wing, and an AR7350 in the fuselage. Then plug the respective right ailerons into say the Aileron channel of each receiver and the left...
04-25-2017, 10:48 AM
Replies: 4
Views: 925
Posted By Sharpeye22

More than one Spektrum receiver in the same plane

I would like to know if it is possible to put an AR6335 (or some other Spektrum receiver) with a battery and switch to drive the servos in the upper wing of a biplane and bind it to my DX18 along...
04-23-2017, 06:10 PM
Replies: 2
Views: 2,338
Posted By Sharpeye22

All the xbus modules connect in series . You...

All the xbus modules connect in series . You plug one into the 1000 and the next into the one you plugged into the 1000 and the next into that one and so on.
04-23-2017, 05:35 PM
Replies: 0
Views: 1,239
Posted By Sharpeye22

Mult Spektrum receivers

I would like to know if it is possible to put an AR6335 with a battery and switch to drive the servos in the upper wing of a biplane and bind it to my DX18 along with an AR9350 in the fuselage to...
12-06-2016, 08:31 AM
Replies: 7
Views: 9,813
Posted By Sharpeye22

It turns out my receiver is one of the locked...

It turns out my receiver is one of the locked one's. It is out of warranty but the AS3X system is not working. I guess the gains somehow got set to zero because it works just fine as a 6 channel...
Forum: Kit Building
12-05-2016, 11:42 AM
Replies: 10
Views: 1,832
Posted By Sharpeye22

Dave, Thankyou for all the trouble you...

Dave,
Thankyou for all the trouble you took and the information you gave me.
I had emailed Top Flight before I stared this thread and their answer was "Sorry we can not help you, that kit is...
Forum: Kit Building
11-28-2016, 12:50 PM
Replies: 10
Views: 1,832
Posted By Sharpeye22

Dave, Here is an option that I wish you...

Dave,
Here is an option that I wish you would consider. Top Flite will make copies of your construction manual, (The booklet you referred to) and your plans and return them to you undamaged if...
Forum: Kit Building
11-28-2016, 10:24 AM
Replies: 10
Views: 1,832
Posted By Sharpeye22

A copy of that booklet would be great. Also did...

A copy of that booklet would be great. Also did the plans not have notes or drawing on them that specified things like how to change the cockpit opening, and outlines for the tail modification and...
11-27-2016, 06:44 PM
Replies: 7
Views: 9,813
Posted By Sharpeye22

Thanks for the reply, I should have mentioned...

Thanks for the reply, I should have mentioned that I tried the model AR636 but it says my serial numbers is not correct for that model. I copied and pasted it from the update program to the...
Forum: Kit Building
11-27-2016, 04:50 PM
Replies: 10
Views: 1,832
Posted By Sharpeye22

Thanks Dave, I have emailed Top Flite...

Thanks Dave,

I have emailed Top Flite looking for plans etc, they could not help me. They did say it only came in an AT6 kit. Not as a separate conversion.
11-27-2016, 10:02 AM
Replies: 7
Views: 9,813
Posted By Sharpeye22

Thanks Andy. I was able to register my two 7...

Thanks Andy. I was able to register my two 7 channels and my one 9 channel, but I also have an AR636A but the 636A is not listed in the drop down box for selecting the model number. Do you know...
Forum: Kit Building
11-26-2016, 05:34 PM
Replies: 10
Views: 1,832
Posted By Sharpeye22

Top Flite Hollywood Zero Conversion.

I have an AT6 kit and would like to build it as a Hollywood Zero. Can anyone possibly help me with a copy of the plans of the Hollywood Zero conversion, and a list of the additional items I would...
11-21-2016, 07:50 AM
Replies: 7
Views: 9,813
Posted By Sharpeye22

Serial number for the AS3X receivers?

On my registration page at the SpektrumRC site I have been trying to register my new AS3X receivers but unlike my other receivers the site requires a serial number for these receivers. The receivers...
Forum: Kit Building
10-18-2016, 03:19 PM
Replies: 1
Views: 372
Posted By Sharpeye22

TF Elder Byplane plans

Can anyone supply me a copy of the plans for the Elder Bipe, are at least full scale drawings of the interplane struts. I picked up a built one at an estate sale but it does not have the interplane...
Forum: Kit Building
10-15-2016, 04:19 PM
Replies: 24
Views: 9,094
Posted By Sharpeye22

This is an old thread but instead of starting a...

This is an old thread but instead of starting a new one I will use this one to ask if anyone can supply me a copy of the plans for the Elder Bipe, are at least full scale drawings of the interplane...
Forum: Gas Engines
09-11-2016, 03:54 PM
Replies: 1,357
Views: 202,703
Posted By Sharpeye22

Thankyou Mustand314, I did as you suggested. I...

Thankyou Mustand314, I did as you suggested. I have a good ground between the shielding and the engine. When I swapped the leads at 1st it ran with both cylinders then the same one as before...
Forum: Gas Engines
09-10-2016, 07:29 PM
Replies: 1,357
Views: 202,703
Posted By Sharpeye22

Need suggestions. I have an FG56T. It has...

Need suggestions.

I have an FG56T. It has been running just fine as late as last weekend. This weekend however, though it started just fine it is only running on one cylinder. Looking from the...
06-30-2016, 05:00 AM
Replies: 2,345
Views: 323,979
Posted By Sharpeye22

Mine has flown with an Evulation 30cc and a Saito...

Mine has flown with an Evulation 30cc and a Saito FG30. It flys pretty much the same with both all though it sounds so much better with the FG30 in it. The FG30 is the gas version of the 180 but it...
Forum: Seaplanes
03-26-2016, 08:05 PM
Replies: 1,448
Views: 219,879
Posted By Sharpeye22

All good points, I was was having problems...

All good points,

I was was having problems with the entire wing tip digging in during taxi which did not allow the plane to get up to takeoff speed. The tip floats is a copy of what is on the...
Forum: Seaplanes
03-26-2016, 12:47 PM
Replies: 1,448
Views: 219,879
Posted By Sharpeye22

I was told to not seal up the main hatch like I...

I was told to not seal up the main hatch like I had planned. I was told that no matter what I did water would get inside so I would need to be able to open the hatch and dry things out in inspect...
Showing results 1 to 25 of 332
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.