Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: kiv
Showing results 1 to 1 of 1
Search took 0.20 seconds.
11-24-2003, 04:45 PM
Replies: 12
Views: 5,605
Posted By kiv

RE: Homemade prop hubs...

You can also use a 1 1/4" or 1 1/2" hole saw. I use it in a lathe, but a drill press will also work fine if you can center it cleanly. You have to be a bit careful to avoid hitting the magnet,...
Showing results 1 to 1 of 1


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.