Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: randy10926
Showing results 1 to 25 of 245
Search took 0.81 seconds.
06-17-2015, 06:56 AM
Replies: 440
Views: 108,086
Posted By randy10926

well I got my V2 last week. It is a very nice...

well I got my V2 last week. It is a very nice looking plane and it really is a full composite. The assembly is very straight forward. Basically epoxy the hinges and control horns and bolt on the...
03-03-2015, 12:01 PM
Replies: 104
Views: 35,794
Posted By randy10926

Installing the Himax 210 Pro is next on my Prolog...

Installing the Himax 210 Pro is next on my Prolog Build. Any suggestions on the thrust incidences? Going to use a 20x12 or 20x13 to start with. Not all that much guidance in the original Prolog...
12-13-2014, 05:36 AM
Replies: 1,677
Views: 332,616
Posted By randy10926

Well I finally adjusted the throttle curve and it...

Well I finally adjusted the throttle curve and it made all the difference in the world. I no longer have a 2 click difference between too slow and an X-15. I am currently at 20%, 43%, 70%, 100% at...
12-06-2014, 04:54 PM
Replies: 1,677
Views: 332,616
Posted By randy10926

flying with a60 8 and apc 20-13. It is a...

flying with a60 8 and apc 20-13. It is a missile. So way suggestions on what prop to use to slow it down?

Randy
12-04-2014, 08:50 AM
Replies: 15
Views: 4,851
Posted By randy10926

I find the Ryobi to be a good fit between cost...

I find the Ryobi to be a good fit between cost and reliability. At 1800 watts continuous and 2200 burst I can also use to for my 18foot travel trailer. And yes it takes 4 or 5 pulls to start cold....
06-04-2014, 02:38 PM
Replies: 71
Views: 14,365
Posted By randy10926

So how did it turn out. I have the 125e version...

So how did it turn out. I have the 125e version and I wonder if they fly alike. I am almost done (last drop of epoxy curing ATM) on a Vanquish, but I already am wondering if it is going to be any...
05-28-2014, 05:39 AM
Replies: 18
Views: 1,993
Posted By randy10926

Sorry I did not make it. I was practicing with...

Sorry I did not make it. I was practicing with several flyers on thursday when I ran short of breathe. My medical appt on Friday morning confirmed that I only had 25% lung capacity that day. I had...
05-28-2014, 05:34 AM
Replies: 48
Views: 9,400
Posted By randy10926

I replaced the APC with a Falcon 19X12. This...

I replaced the APC with a Falcon 19X12. This makes a noticeable change in the aircraft. It flies a little faster but it climbs much better than with the APC. Throttle response seems faster as...
04-25-2014, 07:17 AM
Replies: 48
Views: 9,400
Posted By randy10926

I have a bunch of 35c-70c packs laying around. ...

I have a bunch of 35c-70c packs laying around. Think I may just use them:o
Thanks for the prop and spinner info. Time to order.

The wind 110 flies pretty good on the a50 with the 19X10. I am...
04-20-2014, 05:29 PM
Replies: 48
Views: 9,400
Posted By randy10926

Well the a60 should arrive soon enough for next...

Well the a60 should arrive soon enough for next weekend.

I did get to fly Wind 110 with the a50 and it works well. Even got decent runtimes with my older 3700 packs. I bet the new 5000's will...
04-20-2014, 08:04 AM
Replies: 48
Views: 9,400
Posted By randy10926

I ordered the a60-7xs yesterday after the test...

I ordered the a60-7xs yesterday after the test flying. The a50-16L is going in my Wind 110. The 600 watt difference should make the Mythos 125e a very nice plane.
04-19-2014, 05:49 PM
Replies: 48
Views: 9,400
Posted By randy10926

OK finely got to fly it. I don't think the...

OK finely got to fly it. I don't think the Hacker A50 16L is the enough motor for this plane. Using new 35C batteries the vertical is not enough for advanced. Now to a bigger 8s set-up.
...
03-20-2014, 03:54 PM
Replies: 48
Views: 9,400
Posted By randy10926

well they did not open the local field. They...

well they did not open the local field. They went out to check how it was holding up after the snow melted. It turned out some 'nice' person had let their horses loose on the field. I plan on...
03-09-2014, 07:47 AM
Replies: 48
Views: 9,400
Posted By randy10926

time to go fly.

time to go fly.
03-08-2014, 05:39 AM
Replies: 1,677
Views: 332,616
Posted By randy10926

did you take the mount off and then bolt to the...

did you take the mount off and then bolt to the motor?
Made a template and drill four holes for mount to use. Got three of the holes in the right place. But use the three pre-drilled holes sounds...
03-07-2014, 03:23 PM
Replies: 1,677
Views: 332,616
Posted By randy10926

My Vanquish does not have the 4 holes drilled in...

My Vanquish does not have the 4 holes drilled in the firewall for the torque motor. Any have a template for drilling these?



Randy
02-27-2014, 11:15 AM
Replies: 48
Views: 9,400
Posted By randy10926

Nice - no fences then. Makes for less weight...

Nice - no fences then. Makes for less weight and hangar rash.
4 new 4s-5000 on the way. I will be using some 6s and older 4s pairs for flight testing/trimming.

Should be ready to fly by this...
02-26-2014, 04:27 AM
Replies: 48
Views: 9,400
Posted By randy10926

thanks- signing off this thread

thanks-
signing off this thread
02-25-2014, 05:57 PM
Replies: 48
Views: 9,400
Posted By randy10926

next option. Wing Fences or no wing fences

next option.
Wing Fences or no wing fences
02-25-2014, 10:36 AM
Replies: 48
Views: 9,400
Posted By randy10926

Cool Sebart Mythos 125e

I was going to make a build thread, but the build is so easy a build thread seemed pointless. If you have built a ARF before then you can build this one. Finish is very nice looking. No winkles in...
11-25-2013, 07:57 AM
Replies: 1,677
Views: 332,616
Posted By randy10926

Well I am trying to figure out how I get a prop...

Well I am trying to figure out how I get a prop mounted on the stock motor. All I see is a shaft and no Hub or adapter.
11-22-2013, 09:38 AM
Replies: 1,677
Views: 332,616
Posted By randy10926

Had my for a while, but just started putting it...

Had my for a while, but just started putting it together.

Question. Is the stock Motor supposed to come with a prop adapter?
02-23-2012, 10:27 AM
Replies: 6
Views: 813
Posted By randy10926

RE: 2012 D1 vs. D2 Challenge

Great news, I may even be back flying well enough to compete. Doctors told me I needed to relax more after my visit to the hospital last week. What can be more relaxing than competing?

Randy
01-06-2012, 07:37 AM
Replies: 15
Views: 1,589
Posted By randy10926

RE: Spectrum 10

I really would like to try a tray radio. I fly thumbs/fingers and have started feeling holding the transmitter is cumbersome. Having to move the sticks more sounds great to me. I have also found...
12-09-2011, 12:24 PM
Replies: 15
Views: 1,589
Posted By randy10926

RE: Spectrum 10

How does it compare to the spectrum 8?

Any neat stuff for pattern?

How well does the 'tray' work? Have you tried a set alone tray?

I need to go 2.4 and the 8 and 10 are what I am...
Showing results 1 to 25 of 245
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.