RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: [email protected]
Showing results 1 to 25 of 500
Search took 0.81 seconds.
Forum: Marketplace
10-02-2022, 09:38 AM
Replies: 0
Views: 118
Posted By [email protected]

Rimfire 65cc new

New, unused, Rimfire 65cc electric motor with all the accessories
Purchased for an IMAC plane and decided to go gas instead
price includes shipping
Forum: Marketplace
10-02-2022, 09:36 AM
Replies: 0
Views: 80
Posted By [email protected]

Rimfire 65cc new

New, unused, Rimfire 65cc electric motor with all the accessories
Purchased for an IMAC plane and decided to go gas instead
Forum: Gas Engines
10-01-2022, 07:01 AM
Replies: 4
Views: 237
Posted By [email protected]

Fuji 50's use a line from the crankcase to the...

Fuji 50's use a line from the crankcase to the carb for diaphragm pressure. Make sure the line is there and does not have an air leak in it. check a picture of the fuji 50ei and you will see what I...
Forum: The Clubhouse
08-17-2022, 06:40 AM
Replies: 12
Views: 553
Posted By [email protected]

Maybe it was more "I flew for the first time in a...

Maybe it was more "I flew for the first time in a couple of years" and less tremors. I have seen guys shake so bad that I was afraid they would drop the transmitter and yet the plane flew straight as...
Forum: The Clubhouse
08-03-2022, 05:49 AM
Replies: 15
Views: 951
Posted By [email protected]

Hobby King is owned out of Australia

Hobby King is owned out of Australia
Forum: Glow Engines
05-20-2022, 07:52 AM
Replies: 10
Views: 571
Posted By [email protected]

Try riching the idle airbleed a little. The...

Try riching the idle airbleed a little. The engine is probably leaning out some as it runs and when you idle down it is a little too lean. Check to make sure the center line of
the tank is even with...
03-16-2022, 07:03 AM
Replies: 13
Views: 616
Posted By [email protected]

The amount of oil you could reclaim would be...

The amount of oil you could reclaim would be minimal at best, been running glow engines for 50 years with that set up and I have never seen any gain other than pressurizing the tank.
Larry
Forum: Marketplace
03-13-2022, 03:29 PM
Replies: 0
Views: 250
Posted By [email protected]

Wanted---Wing for Top Flite ARF Giant Corsair

Wanted, new or used TF F4U giant scale ARF wing
Forum: The Clubhouse
02-24-2022, 08:17 AM
Replies: 4
Views: 345
Posted By [email protected]

If you are using windows 7 or 10 go download " ...

If you are using windows 7 or 10 go download " power toys for windows" for what ever version your using. It contains an image resizer that works very well for reducing the size of pictures
Larry
Forum: The Clubhouse
02-07-2022, 07:19 AM
Replies: 7
Views: 996
Posted By [email protected]

Nice that they finally got it Wright!

Nice that they finally got it Wright!
Forum: Gas Engines
12-01-2021, 08:43 AM
Replies: 3
Views: 478
Posted By [email protected]

the secret to cooling an inline engine is too...

the secret to cooling an inline engine is too have the entry air come in one side of the cowl and exit through the two cylinders to the other side of the cowl, The air has to go through the fins, not...
Forum: Glow Engines
11-22-2021, 07:27 AM
Replies: 3
Views: 549
Posted By [email protected]

The only reason it would have a pressure tap is...

The only reason it would have a pressure tap is if the carb had been changed for one with a bigger throat so it would develop more power (racing probably) or someone wanted to run a pump for some...
Forum: The Clubhouse
05-28-2021, 12:09 PM
Replies: 138
Views: 81,732
Posted By [email protected]

Crap, like beauty, is in the eye of the beholder....

Crap, like beauty, is in the eye of the beholder. Banana Hobby planes have always seemed to me to be high-middle end products. Not E-flite or Motion R/C but way better than Dynam or HobbyKing.
Larry
Forum: Glow Engines
05-14-2021, 07:22 AM
Replies: 2,290
Views: 269,547
Posted By [email protected]

The X means that it is schnuerle ported. Straight...

The X means that it is schnuerle ported. Straight G series motors were all loop ported. Looks like it was used on a car or truck from the intake and exhaust set up. It uses the same needle valve as...
Replies: 3
Views: 644
Posted By [email protected]

First check and see if the charger transmitter...

First check and see if the charger transmitter plug has voltage, if it is the phone jack type the wires can break inside the plug from bending. If you have voltage, which should be over 9.2 for most...
Forum: Gas Engines
12-09-2020, 07:54 AM
Replies: 617
Views: 172,993
Posted By [email protected]

yes, but I don't know what he does or if it had...

yes, but I don't know what he does or if it had anything to do with failure.
Larry
Forum: Gas Engines
12-08-2020, 10:10 AM
Replies: 617
Views: 172,993
Posted By [email protected]

I agree, don't know what brand of oil he used but...

I agree, don't know what brand of oil he used but he was using suggested ratio. This is one of the new series 90's with the improvements. I just don't like running a gas engine with plain bearings or...
Forum: Gas Engines
12-08-2020, 09:56 AM
Replies: 617
Views: 172,993
Posted By [email protected]

oil was drained before taking picture, but I tend...

oil was drained before taking picture, but I tend to think 15 to 1 with no bushings or bearings is too high, 10 would be better, but messy. I went back and looked at crank to make sure the crank pin...
Forum: Gas Engines
12-08-2020, 08:46 AM
Replies: 617
Views: 172,993
Posted By [email protected]

I think he was using the prop size suggested in...

I think he was using the prop size suggested in the engine manual, rpm on ground was 5200 or 5500. I did not look at the tach. Oil was 15 to 1, failure was one of the slave rods galled the master rod...
Forum: Gas Engines
12-08-2020, 08:11 AM
Replies: 617
Views: 172,993
Posted By [email protected]

Here is a picture of one of our members G90 after...

Here is a picture of one of our members G90 after the first, short, flight. Self explanatory
...
Forum: Marketplace
11-21-2020, 04:29 PM
Replies: 2
Views: 619
Posted By [email protected]

Robart retracts and spare parts for Top Flite Zero

Retracts, two mains and tail wheel unit, from my dear, unlamented TF giant Zero.
Gear in used good condition, works fine. Also included, used fiberglass strut covers and new drop tank and a spare...
Forum: Gas Engines
10-24-2020, 07:23 AM
Replies: 9
Views: 1,435
Posted By [email protected]

Check for a crack in the carb insulator block,...

Check for a crack in the carb insulator block, use a strong light as they can be hard to see. Very common cause of your problem, usually caused by over-tightening the block and carb bolts. allows the...
Forum: RC Humor
10-10-2020, 08:04 AM
Replies: 2
Views: 3,673
Posted By [email protected]

funny things at the field (for real!)

To lighten up things this year, here is a couple true storys from our club many years ago.

George and Sam were out at the flying field one Sunday when George came up to Sam and ask to borrow a new...
10-06-2020, 07:07 AM
Replies: 299
Views: 72,550
Posted By [email protected]

Replace the bearings

Replace the bearings
Forum: Gas Engines
09-06-2020, 06:55 AM
Replies: 617
Views: 172,993
Posted By [email protected]

Had one of our warbird guy's new 90 break a rod 6...

Had one of our warbird guy's new 90 break a rod 6 min into first flight, bottom line is poor design.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.