RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: BrentJ
Showing results 1 to 25 of 41
Search took 0.61 seconds.
04-19-2009, 09:42 PM
Replies: 10
Views: 830
Posted By BrentJ

RE: NEED ADVICE BADLY...PLEASE HELP

Looks like it just needs a main (SPUR) gear instead of an entire tranny...the tranny that came in that car is pretty good. The engine looks a little tired. You can take the care to your LHS and...
04-19-2009, 09:32 PM
Replies: 2
Views: 711
Posted By BrentJ

RE: Blinky & Blinky adaptor for Thunder power

Just make sure that the black wire on the cell balancing bundle from the battery is on the far left pin on the balancer when looking at it from the side with the LEDs...blinky's can be used on lots...
09-24-2006, 11:33 AM
Replies: 9
Views: 850
Posted By BrentJ

RE: Castle or Eflite ESC for heli.Wuts best??

I agree. The Castle ESC is superior to the eflite. This is an area that you do not want to overlook and go cheap on...spend a little extra. The Castle ESC will run your motor smoother and cooler...
09-24-2006, 11:29 AM
Replies: 4
Views: 623
Posted By BrentJ

RE: HDX-450 pitch, possibly head speed problems?

For the size of motor you are using I would suggest a 14tooth pinion. The 11 is way to small and since your motor is already a lower rpm per volt this change to a 14 pinion should help quite a bit. ...
01-28-2006, 09:15 PM
Replies: 1,382
Views: 170,335
Posted By BrentJ

RE: GP Cap 580 1/3 scale

You guys are killing me...I want to see some pictures.

[&o]
01-28-2006, 09:00 PM
Replies: 11
Views: 1,064
Posted By BrentJ

RE: APC prop and DA-50

You should not need the 6.0...most ignitions are made to take the 4.8 volt packs...if you want greater power and time between charges then get a high mAh pack. I use a 2400mAh 4.8 NMH pack on my...
01-23-2006, 04:44 PM
Replies: 28
Views: 2,988
Posted By BrentJ

RE: Perry Show - The Taxman Cometh!

Yah...I know. Perry is an awesome event..I go every year. It is just fun to poke at the TAXMAN whenever I get the chance.


See you guys there!
[8D]
01-22-2006, 11:19 PM
Replies: 28
Views: 2,988
Posted By BrentJ

RE: Perry Show - The Taxman Cometh!

How do you think they are paying for all of the FREE college educations to GA high school students...makes you think a little...and now you know.

Hey taxman...kiss my left aileron!! :D


...
01-22-2006, 11:11 PM
Replies: 1
Views: 537
Posted By BrentJ

RE: 2006 Madison County R/C Swap Meet

Hey Andrew...where is the NARCA flying site located??


Brent

[8D]
Forum: Gas Engines
01-20-2006, 11:50 AM
Replies: 16
Views: 3,297
Posted By BrentJ

RE: Zenoah G38 break-in details

Yeah...sorry about that. That is the one I use but I do not go exactly to 100:1....usually between 75:1 to 85:1
Forum: Gas Engines
01-18-2006, 10:06 PM
Replies: 12
Views: 1,105
Posted By BrentJ

RE: What do you do with the tank vent?

That is a great idea...tried it and it works.
Forum: Gas Engines
01-18-2006, 09:58 PM
Replies: 2
Views: 701
Posted By BrentJ

RE: 3-line fuel system

Hello,


3 line system:

You need to run three lines from the tank. 2 of them need to be attached to fuel clunks(pickups) in the tank. One of these is for fuel line to the carb and the...
Forum: Gas Engines
01-18-2006, 09:53 PM
Replies: 10
Views: 1,073
Posted By BrentJ

RE: Fuel pressure

It is not a zenoah...it looks like between a 23cc to 30cc engine.
Forum: Gas Engines
01-18-2006, 09:51 PM
Replies: 14
Views: 1,632
Posted By BrentJ

RE: gas fuel dot ?

Stay away from the 2 line setup...3 lines is easier to setup and works better for your engine when running gas. When using glow I install fuel-filler valves so that fuel go directly to the tank. ...
Forum: Gas Engines
01-18-2006, 09:23 PM
Replies: 7
Views: 617
Posted By BrentJ

RE: G26 carb stack, should I installed it or ditch it inside the cowl?

The stack will not matter at all in the cowl. I have tried it and have had neither less mess or a change in power. I say ditch the stack and leave more room for air to flow and cool. IMHO

...
Forum: Gas Engines
01-18-2006, 09:20 PM
Replies: 3
Views: 842
Posted By BrentJ

RE: How many of you have broken G26 prop stud? What you do?

I am a Zenoah flyer and have seen this problem with others. They are just worried and think that they are torquing head bolts on a race car. I use a good rule...I tighten the nut down all the way...
Forum: Gas Engines
01-18-2006, 09:09 PM
Replies: 6
Views: 514
Posted By BrentJ

RE: Fuel line size?

I agree...medium is fine and so is large. Like he said...they only draw as much as they need and the fule that is about to be burned is not in the line anyway..it is in the diaphram waiting to be...
Forum: Gas Engines
01-18-2006, 09:07 PM
Replies: 8
Views: 9,606
Posted By BrentJ

RE: Walbro carbs, difference w/wo primer bulb

I have DA's, W's, and Zenoahs and have never had any problems with any of them...nor have anybody that I know that also have these engines. As far as I am concerned the walbro's come from the...
Forum: Gas Engines
01-18-2006, 08:53 PM
Replies: 12
Views: 1,105
Posted By BrentJ

RE: What do you do with the tank vent?

I agree mostly with every post. I use a check valve on mine and also have a plug for when I am not flying. Just do not forget to take out when flying or you will starve the engine of fuel and kill...
Forum: Gas Engines
01-18-2006, 08:28 PM
Replies: 4
Views: 681
Posted By BrentJ

RE: Big Stik 1.20 with G-26???

G26 will do great and I agree with putting a wide 18x8 on it. I have a 15 pound bipe w/smoke and it flies out of sight....very nice engine.
Forum: Gas Engines
01-18-2006, 08:26 PM
Replies: 16
Views: 3,297
Posted By BrentJ

RE: Zenoah G38 break-in details

ALL great info....I use amsoil at nearly 80:1 in my DA50, G26, and G45. I have never needed to bench run these as they are nearly perfect from the factory. I will say though that I have seemed to...
Forum: Gas Engines
01-18-2006, 08:22 PM
Replies: 3
Views: 727
Posted By BrentJ

RE: Zenoah G38 repair question

You should just be able to 'push' it into the old boot. You might need to put a little CA where the wire insulation and the back of the boot meet. Hope this helps.
01-18-2006, 08:17 PM
Replies: 15
Views: 2,995
Posted By BrentJ

RE: Great Planes Extra 300

Which Extra 300 is this?? I have a Great Planes Extra 300 .40 that is shelved and would be willing to send the whole thing to you for a deal. I damaged the landing gear about 6 months ago and...
11-29-2005, 12:42 PM
Replies: 4
Views: 633
Posted By BrentJ

RE: Right stick causes ailerons to move irradically

I had a few others ask me that too...I'm not moving them past center at all...this is just a really wierd situation. I have been flying for nearly 20 years and have never seen this happen before. ...
11-28-2005, 03:27 PM
Replies: 4
Views: 633
Posted By BrentJ

Right stick causes ailerons to move irradically

PLEASE HELP!

I have the Heli version of the JR 8103. I am using the R700 and 811 servos.

When I move the right stick for ailerons slowly everythings operates as it should. However, when...
Showing results 1 to 25 of 41
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.