Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Showing results 1 to 25 of 83
Search took 0.78 seconds.
01-12-2004, 01:43 AM
Replies: 18
Views: 1,040

RE: YS Engine Or ....?

Like everyone has said do not adjust a YS very fast. Make small Adjustment and wait a couple of minutes then cycle the throtle. Also make sure the fuel sustem is completly air tight. Preasure check...
01-12-2004, 01:10 AM
Replies: 14
Views: 1,145

RE: Too much power?

Well Flying fever. Sounds about right to me. Power is a pilots best friend. I have a LT 40 with a YS63 mounted on the plane and when I was a Newbie it saved my hide several times when landing. Full...
Forum: Beginners
12-17-2003, 01:33 AM
Replies: 12
Views: 656

RE: Too Much Power?

Increase the down and right thrust and make sure the ailerons are trimed correctly. Also you might decrease the wing incidence a little.
Replies: 5
Views: 861

RE: equivalent motor

Hello. Does anybody know of a site that showes the dimentions of motors such as case size?
Forum: Beginners
07-21-2003, 03:50 AM
Replies: 10
Views: 755

Newbies first time out the hard way!

Welcome Suthrn.

Where are you located in the Bluegrass. I am in the western section.

Hey Tinman how are things in Columbia. Plan on being in Robards at the fly in the third weekend in...
Forum: Beginners
07-21-2003, 03:34 AM
Replies: 33
Views: 1,628

question about beginner plane

Plan on spending around $700.00 dollars to get into RC planes. Electrics that will be able to seriously fly are not that much cheaper. RC trucks or cars experience will not be of any help in flying....
Forum: Beginners
07-21-2003, 03:25 AM
Replies: 8
Views: 495

cost to start

Welcome Cyrus

In a word how serious ar you?

Find a club close and go and visit. See what they are using as far as equipment and if you still want to try RC then expect to shell out around a...
Forum: Beginners
07-21-2003, 03:12 AM
Replies: 31
Views: 1,205

J-3 cub engine direction

Welcome to this wonderful and demanding Hobie. I was wondering what brand and type of transmitter you have. As a beginner I would advise you to program some expo in to the control surfaces. That way...
07-14-2003, 05:06 AM
Replies: 1
Views: 488

Jr 8103a

Danny how do you change the bar graph one the first screen after you turn the transmitter on so they are centered after the trim flight.

Thanks
Forum: RC Humor
07-14-2003, 02:05 AM
Replies: 19
Views: 1,844

heli ?

RSands

No problem. Just point it in a direction and it will go forever.

I do like to fly it to scale during take off I just use 1/4 throttle.

But when I do not take my medicine it will go...
Forum: RC Humor
07-13-2003, 04:40 AM
Replies: 19
Views: 1,844

heli ?

Hey Dago Red

What is the point to have a slow airplane that is under powered?

All of my planes have at least twice the engine size recommendation.

Heck my pizza box has a OS46LA.
Tiger 60...
Forum: Beginners
07-13-2003, 03:19 AM
Replies: 14
Views: 1,062

beginner / Trainer... First SLAM DUNK OUCH...

Sims are great for learning control stick movements, but it will never take the place of actual air time.
Forum: RC Humor
07-13-2003, 03:10 AM
Replies: 19
Views: 1,844

heli ?

rotor blades are airfoils and when spun generate lift.
Forum: Beginners
07-11-2003, 07:27 PM
Replies: 28
Views: 1,897

Lt-40 W/ .46fx ???

Pilottx

You sound as though you have a good instructor. Teaching you the basics. That is what you need. Now their was a lot of suggestions about power. Shucks I have a YS 63 with a 11x7 three...
Forum: Beginners
07-11-2003, 04:16 AM
Replies: 28
Views: 1,897

Lt-40 W/ .46fx ???

With that size engine I would recommend a 10x6 master airscrew prop. As far as the roll rate I would not worry about that until later. Right now concentrate on flying the plane where you want it to...
Forum: Beginners
07-10-2003, 12:01 AM
Replies: 9
Views: 734

Question about "Pinch Test"

Amen Chassan their are lots of ways to check engine performance. I am satisfied if it starts and runs so I can fly and enjoy my plane and life becomes no better for me.
Forum: Beginners
07-09-2003, 11:54 PM
Replies: 14
Views: 2,951

My plane does a roll to the right but not to the left, why?

If you have dual servos (one on each side) have you checked servo travel in the radio? Some times their is a difference with travel when using a computer transmitter. Are they tied together with a y...
07-05-2003, 03:16 AM
Replies: 2
Views: 541

radio fuse

Had the same problem turned out to be the charging jack lead from the charger. Replaced the end and the problem has gone away.
Forum: Beginners
06-24-2003, 04:20 AM
Replies: 5
Views: 635

engine for dp 120 ultimate

Hello Otter........I have as YS120 on a 1/4 scale clipped wing Cub. Does really well with scale flying. You know with all that wing and drag. It looks real. With my experience YS engines give you...
Forum: Beginners
06-24-2003, 03:20 AM
Replies: 5
Views: 635

engine for dp 120 ultimate

Hello Listed.

I have a YS 140 with a 18x6 prop and a 24 ounce plastic soft drink bottle for the fuel. Love this combo it will hang and torque roll and knife edge for as far as I can see has great...
Forum: Beginners
06-23-2003, 02:33 AM
Replies: 6
Views: 580

i'm a begginer

Tecme

What state are you in.
Forum: Beginners
06-23-2003, 02:21 AM
Replies: 18
Views: 1,110

Too Lean Or Too Rich

What type of engine is the main question. 2 or 4 stroke and manufacturer. They are all different.
Forum: Beginners
06-23-2003, 02:16 AM
Replies: 6
Views: 928

2 stroke vs 4 stroke size comparison ????

Four strokes generally give you more torque at lower rpms and will pull harder. If you look into the hp on four strokes YS has the most. Their web site is www.ysperformance.com.

But the main...
Forum: Beginners
06-23-2003, 02:01 AM
Replies: 7
Views: 476

Overflow Bottle?

A drop hear and a drop their adds up. I have a free flight every couple of weeks.
Forum: Beginners
06-20-2003, 03:55 AM
Replies: 9
Views: 832

Sheesh !! Slow Stick

What are you talking about. What type of plane and equipment do you have. Are you trying this for the first time or do you have some training or experience.
Showing results 1 to 25 of 83
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.